Simple Toaster Controller PT8A2512

PT8A2512
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Simple Toaster Controller
Features
Description

Operating voltage : 3.5~5.5V
The PT8A2512 is a CMOS LSI chip designed for

Few external components
simple toaster. It provides low cost solution for toaster.

No start to turn on Relay without oscillation.
The chip is enclosed in a 4 pin TO-94.

TO94-4 package
Applications

Toaster.
Pin Assignment
PT8A2512NE
1-RELAY
2-VCC
3-OSC
4-GND
1 2 3 4
TO-94
Fig 2 PT8A2512NE pin assignment
Pin Description
Name
Pin No.
Type
Description
RELAY
1
O
Relay control output, high active
VCC
2
-
Power supply
OSC
3
I/O
GND
4
-
Input/output of RC oscillator
GND
Block Diagram
Power on
VC C
Re set
GND
O SC
Frequen cy
Di vi der
System
O scil l ator
RELAY
PT8A2512NE
Fi g1 Functio n B lo ck Diag ra m
12-07-0006
PT0204-4
1
07/06/2012
PT8A2512
Simple Toaster Controller
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Maximum Rating
Storage Temperature………………………………………… - 25oC to +85oC
Supply Voltage to Ground Potential (Inputs & VCC only)……… - 0.5 to +5.5V
Supply Voltage to Ground Potential (Outputs only) …………… - 0.5 to +5.5V
DC Input Voltage ………………………………………………- 0.5V to +5.5V
Output Current ………………………………………………………… 20mA
Power Dissipation……………………………………………………… 500mW
Note:
Stresses greater than those listed under AXIMUM
RATINGS may cause permanent damage to the
device. This is a stress rating only and functional
operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure
to absolute maximum rating conditions for extended
periods may affect reliability.
Recommended Operating Conditions
Symbol
Pin
Description
Min
Typical
Max
Unit
VCC
VCC
Supply voltage
3.5
4
5.5
V
TA
-
Operation Temperature
0
25
85
C
DC Electrical Characteristics
(TA = 0 ~ 85ºC, unless otherwise noted)
Symbol
Description
Test Conditions
Min
Typical
Max
Unit
IOH
Output source current
V CC = 3.5V, VOH=2.0V
-12
-
-
mA
IOL
Output sink current
V CC = 3.5V, VOL=0.5V
0.5
-
-
mA
FOSC
Frequency of oscillator
V CC = 4.0V Rosc=56K,Cosc=223
952
1024
1096
Hz
AC Electrical Characteristics
(TA = 0 ~ 85ºC, unless otherwise noted)
Symbol
Description
Test Conditions
Min
Typical
Max
Unit
ICC
Current consumption
V CC = 4.0V Rosc=56K,Cosc=223
-
-
100
uA
12-07-0006
PT0204-4
2
07/06/2012
PT8A2512
Simple Toaster Controller
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Function Description
System oscillator and Frequency divider
It provides one-stop timer for Toaster after power on.
In general, Fosc=1KHz, RELAY will shut down after 30s.
Power on reset
Used to reset internal logic
Application Circuit
CONTROL BOARD
SLOT1
C2
2 20 UF/1 6 V
R6
1K
PO WE R1
R1
1 N40 0 4
R2
R4
SLOT2
2 40
VZ1
3 .9 V
C1
4 7UF
HEATER
D1
R7
VCC
R3
R5
1 N41 4 8
D2
L1
LEVER
IC1
PT8 A2 5 12 NE
4
GND RELAY
3
OSC
VCC
1
2
220V
R9
Q1
S1
2K
8 05 0
CANCEL
R8
C3
2 23
SW1
*
VCC
R1 0
2 50 K
12-07-0006
PT0204-4
3
07/06/2012
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
PT8A2512
Simple Toaster Controller
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Mechanical Information
TO94-4
PKG. DIMENSIONS(MM)
SYMBOL
MIN
MAX
A
1.40
1.80
A1
0.70
0.90
A2
0.50
0.70
b
0.36
0.50
b1
0.38
0.55
c
0.36
0.51
D
4.98
5.28
D1
3.78
4.08
E
3.45
3.75
e
1.27 BSC
e1
L
θ
3.71
3.91
14.90
15.30
45ºBSC
Note:
1) Controlling dimensions in millimeters.
Ordering Information
Part Number
PT8A2512NE
Package Code
N
Package
Lead free TO94-4
Note:

E = Pb-free

Adding X Suffix= Tape/Reel
Pericom Semiconductor Corporation  1-800-435-2336  www.pericom.com
Pericom Technology Incorporation reserves the right to make changes to its products or specifications at any time, without notice, in order to improve design or
performance and to supply the best possible product. Pericom Technology does not assume any responsibility for use of any circuitry described other than the
circuitry embodied in Pericom Technology product. The company makes no representations that circuitry described herein is free from patent infringement or other
rights, of Pericom.
12-07-0006
PT0204-4
4
07/06/2012