2015-4장-02 2015.1.20 03:49 PM 페이지168 태산아이인쇄그룹(국) 2261-2488 2400DPI 175LPI MINIATURE ALUMINUM ELECTROLYTIC CAPACITORS NS Non-Polarized, Height 7mmL Series Non-polarized Solvent Proof ・Non-polarized series with 7mmL height ・Load life of 2000 hours at 85° C ・Complied to the RoHS directive Item Characteristics Operating temperature range Leakage current max. Capacitance tolerance -40 ~ +85° C I = 0.05CV or 10μA whichever is greater (after 2 minutes) ±20% at 120Hz, 20° C WV tanδ Dissipation factor max. (at 120Hz, 20° C) 6.3 0.24 10 0.20 WV Z-25° C/Z+20° C Z-40° C/Z+20° C Low temperature characteristics (Impedance ratio at 120Hz) 25 0.16 6.3 4 8 Leakage current Capacitance change tanδ Test method Load life (after application of the rated voltage for 2000 hours at 85° C) 16 0.17 35 0.15 40 0.14 10 3 6 50 0.12 63 0.10 16~25 2 4 35~63 2 4 Less than specified value Within ±20% of initial value Less than 200% of specified value Polarity reverse each 250 hours After 1000 hours no load test, leakage current, capacitance and tanδare same as load life value. The measurement shall be performed at 20° C by the KS C IEC 60384 - 4 Shelf life (at 85° C) Unit : mm ● DRAWING Ød±0.05 Tinned copper-ply wire Insulating sleeve ØD+0.5 max. ØD P±0.5 15 min. L+βmax. 4 5 6.3 P 1.5 2.0 2.5 Ød 0.45 0.5 β 1.0 0.5 1.5 4 min. ● DIMENSIONS & MAXIMUM PERMISSIBLE RIPPLE CURRENT WV μF 6.3 10 16 25 35 40 50 63 1.0 4×7 13 4×7 14 1.5 4×7 16 4×7 17 2.2 4×7 19 5×7 24 3.3 4.7 6.8 10 4×7 26 4×7 20 4×7 21 4×7 18 5×7 27 6.3×7 34 6.3×7 37 6.3×7 40 4×7 23 4×7 24 5×7 29 5×7 25 5×7 32 5×7 33 6.3×7 39 5×7 29 6.3×7 47 6.3×7 48 6.3×7 41 4×7 31 5×7 39 15 4×7 35 5×7 44 6.3×7 55 22 5×7 49 6.3×7 62 6.3×7 67 33 6.3×7 69 6.3×7 76 47 6.3×7 83 Ripple current (mA rms) at 85° C, 120Hz Case size ØD×L (mm) ● FREQUENCY COEFFICIENT OF PERMISSIBLE RIPPLE CURRENT 168 Frequency 50Hz 120Hz 1kHz 10kHz≦ Coefficient 0.75 1.00 1.55 2.00