MINIATURE ALUMINUM ELECTROLYTIC CAPACITORS Extremely Low Impedance Series RZ Long Life Solvent Proof Low Impedance Extremely low impedance at high frequency High reliability withstanding 5000 hours load life at 105 C (2000 / 3000 hours for smaller case sizes as specified below) Ideally suited for use in switching power supplies Complied to the RoHS directive Item Characteristics -55 ~ +105 C I = 0.01CV or 3 A whichever is greater (after 2 minutes) I = 0.03CV or 4 A whichever is greater (after 1 minute) 20% at 120Hz, 20 C Capacitance > 1000 F : tan increases by 0.02 for each 1000 F from below value 6.3 10 16 25 35 50 WV 0.22 0.19 0.16 0.14 0.12 0.10 tan Operating temperature range Leakage current max. Capacitance tolerance Dissipation factor max. (at 120Hz, 20 C) WV Z-55 C/Z+20 C Low temperature characteristics (Impedance ratio at 120Hz) 6.3, 10 4 16 ~ 35 3 63 0.08 50, 63 2 After an application of DC bias voltage plus the rated AC ripple current for 5000 hours at 105 C. The measurement shall meet the following limits. The DC voltage plus the peak AC voltage combined must not exceed the rated voltage. Less than specified value Within 20% of initial value Less than 200% of specified value Leakage current Capacitance change tan Load life D Life time D 6.3 2000 hours D=8 3000 hours D 10 5000 hours After 1000 hours no load test, leakage current, capacitance and tan are same as load life value. The measurement shall be performed at 20 C by the KS C IEC 60384 - 4 Less than specified value Within 20% of initial value Less than 150% of specified value Leakage current Capacitance change tan Shelf life (at 105 C) Unit : mm DRAWING 0.05 Tinned copper-ply wire D 0.5 max. d P L Safety vent max. 15 min. D 5 6.3 8 10 12.5 16 18 P 2.0 2.5 3.5 5.0 5.0 7.5 7.5 d 0.5 0.5 0.6 0.6 0.6 0.8 0.8 0.5 1.5 4 min. 2.0 6.3 up) FREQUENCY COEFFICIENT OF PERMISSIBLE RIPPLE CURRENT Frequency 120Hz 1kHz 10kHz 50kHz F 100kHz 0.40 0.65 0.82 0.91 1.00 47 ~ 220 0.50 0.70 0.84 0.92 1.00 330 ~ 680 0.55 0.75 0.86 0.93 1.00 1000 ~ 1500 0.60 0.80 0.88 0.94 1.00 2200 ~ 0.70 0.85 0.90 0.95 1.00 ~ 33 105 MINIATURE TYPES Insulating sleeve MINIATURE ALUMINUM ELECTROLYTIC CAPACITORS RZ series DIMENSIONS & MAXIMUM PERMISSIBLE RIPPLE CURRENT WV 6.3 10 D L (Ω)max. (mA rms) 20 C 105 C 100kHz 100kHz (mm) F D L (mm) (Ω)max. (mA rms) 20 C 105 C 100kHz 100kHz 25 Impedance Ripple current Impedance Ripple current Impedance Ripple current Impedance Ripple current Item 16 D L (mm) (Ω)max. (mA rms) 20 C 105 C 100kHz 100kHz D (mA rms) 20 C 105 C 100kHz 100kHz (mm) 33 5 11 0.80 155 5 11 0.80 155 6.3 11 0.55 210 5 11 0.80 155 6.3 11 0.50 220 6.3 11 0.36 260 6.3 11 0.35 265 8 11.5 0.24 383 8 11.5 0.23 388 8 11.5 0.16 460 600 47 68 (Ω)max. L 100 5 11 0.85 150 6.3 11 0.55 210 150 6.3 11 0.49 225 6.3 11 0.35 265 220 6.3 11 0.30 285 8 11.5 0.24 387 8 11.5 0.16 460 10 12.5 0.13 330 8 11.5 0.20 292 8 11.5 0.16 460 10 12.5 0.12 625 10 16 0.095 750 470 10 12.5 0.14 575 10 12.5 0.13 600 10 16 0.09 770 10 20 0.065 1020 680 10 16 0.11 700 10 16 0.09 770 10 20 0.065 1020 12.5 20 0.046 1392 1000 10 20 0.075 950 10 20 0.060 1060 12.5 20 0.047 1411 12.5 25 0.036 1660 1500 10 25 0.055 1220 12.5 20 0.045 1417 12.5 25 0.036 1660 16 20 0.034 1770 2200 12.5 20 0.043 1438 12.5 25 0.034 1710 16 20 0.033 1800 16 25 0.028 2051 3300 12.5 25 0.034 1710 16 20 0.031 1850 16 25 0.027 2095 16 35.5 0.020 2680 4700 16 25 0.032 1935 16 31.5 0.023 2420 16 35.5 0.020 2680 18 40 0.018 2960 6800 16 31.5 0.024 2370 16 35.5 0.020 2680 18 35.5 0.018 2900 10000 16 40 0.020 2750 18 40 0.017 3040 15000 18 40 0.018 2960 WV 35 Item D L (mm) F 106 50 Impedance Ripple current (Ω)max. (mA rms) 20 C 105 C 100kHz 100kHz D L (mm) 63 Impedance Ripple current (Ω)max. (mA rms) 20 C 105 C 100kHz 100kHz D L (mm) Impedance Ripple current (Ω)max. (mA rms) 20 C 105 C 100kHz 100kHz 1.0 5 11 4.0 36 1.5 5 11 3.8 45 2.2 5 11 3.5 54 3.3 5 11 3.0 66 4.7 5 11 2.2 81 6.8 5 11 1.8 91 10 5 11 1.8 115 5 11 1.06 135 15 5 11 0.93 145 6.3 11 0.73 185 11 0.52 215 22 5 11 0.75 160 6.3 11 0.65 195 6.3 33 6.3 11 0.49 225 6.3 11 0.43 240 8 11.5 0.35 320 47 6.3 11 0.34 270 8 11.5 0.30 344 8 11.5 0.25 365 68 8 11.5 0.24 384 8 11.5 0.20 410 10 12.5 0.19 495 100 8 11.5 0.16 460 10 16 0.16 581 10 20 0.12 750 150 10 12.5 0.12 625 10 20 0.10 820 10 25 0.09 950 220 10 16 0.09 770 10 25 0.075 1040 12.5 20 0.065 1140 330 10 20 0.060 1060 12.5 20 0.075 1281 12.5 25 0.049 1420 470 12.5 20 0.046 1401 12.5 25 0.044 1500 16 25 0.042 1700 680 12.5 25 0.036 1660 16 20 0.040 1630 16 31.5 0.032 2050 1000 16 20 0.034 1770 16 31.5 0.030 2120 18 35.5 0.029 2280 1500 16 31.5 0.028 2385 16 40 0.026 2410 2200 16 35.5 0.020 2680 18 40 0.024 2560 3300 18 40 0.017 3040