VC670M-TO46FW-2 v 1.0 21.01.2015 Description VC670M-TO46FW-2 is a multi mode red VCSEL emitting at typically 670 nm with rated output power of 1.0 mW cw, mounted into a standard TO-46 package and sealed with a flat window cap. The VCSEL works under low forward current and voltage. Maximum Ratings Parameter Values Symbol Min. IF VF Forward Current Reverse Voltage (@ 10µA) Operating Temperature Storage Temperature Lead Solder Temperature * TCASE TSTG TSLD Unit Max. 8 5 + 50 + 85 + 260 - 20 - 40 mA V °C °C °C * must be completed within 10 seconds Laser Characteristics (TCASE=25°C) Parameter Symbol λPeak ∆λ PO ITH IF VF Ө Η RD VB RTH Emission Wavelength Spectral Width Optical Output Power Threshold Current Operating Current Operating Voltage Beam Divergence (Full Width) Slope Efficiency Dynamic Resistance Breakdown Votage ESD threshold Min. 660 Values Typ. 670 1.0 2.0 5 2.1 14 0.2 50 14 Max. 690 0.85 3.5 2.5 30 0.4 90 19 100 Unit nm nm mW mA mA V deg mW/mA Ω V V Thermal Characteristics Parameter Symbol Min. Values Typ. Max. Test Conditions Unit Max. Operating Temperature Optical Output Power PT=50°C 0.5 TC=50°C, 5mA mW ITH Temperature Variation η Temperature Variation λ Temperature Variation ΔITH Δη / ΔT Δλ / ΔT 1 -0.8 0.05 TC=-20 to 50°C TC=-20 to 50°C,5mA TC=-20 to 50°C,5mA mA %/°C nm/°C www.roithner-laser.com 1 Outline Dimensions TO46FW TO-46 with flat window All Dimensions in mm Electrical Connection Lead Pin 1 Pin 2 Pin 3 www.roithner-laser.com Description LD Anode n.c. LD Cathode 2 Precautions Static Electricity: VCSELs are sensitive to electrostatic discharge (ESD). Precautions against ESD must be taken when handling or operating these VCSELs. Surge voltage or electrostatic discharge can result in complete failure of the device. Safety Advice: This VCSEL emits concentrated red light which can be hazardous to the human eye and skin. This diode is classified as CLASS 2 laser product according to IEC 60825-1 and 21 CFR Part 1040.10 Safety Standards. Operation: Do only operate VCSELs with a current source. Running these LEDs from a voltage source will result in complete failure of the device. Current of a LED is an exponential function of the voltage across it. Usage of current regulated drive circuits is mandatory. © All Rights Reserved The above specifications are for reference purpose only and subjected to change without prior notice www.roithner-laser.com 3