SMC700 TECHNICAL DATA Visible LED, SMD AlGaAs SMC700 is a AlGaAs LED mounted on a ceramic SMD package and sealed with silicone or epoxy resin for damp proof. On forward bias, it emits a radiation of typical 3 mW at a peak wavelength of 700 nm. Specifications • • • • Structure: AlGaAs Peak Wavelength: typ. 700 nm Optical Output Power: typ. 3 mW Package: Ceramic SMD, silicone / epoxy resin Absolute Maximum Ratings (Ta=25°C) Item Symbol Value Power Dissipation PD 110 Forward Current IF 50 Pulse Forward Current** IFP 200 Reverse Voltage VR 5 Operating Temperature Topr -20 … +80 Storage Temperature Tstg -30 … +80 Soldering Temperature * Tsol 240 Unit mW mA mA V °C °C °C (Unit: mm) * must be completed within 5 seconds ** max duty cycle 1%, max puls width 10µs Electro-Optical Characteristics Item Forward Voltage Reverse Current Total Radiated Power* Radiation Intensity Peak Wavelength Half Width Viewing Half Angle Rise Time Fall Time Symbol VF IR PO IE λP Δλ Θ1/2 tR tF Condition IF = 20 mA VR = 5 V IF = 20 mA IF = 20 mA IF = 20 mA IF = 20 mA IF = 20 mA IF = 20 mA IF = 20 mA Min. 1.5 1.0 - Typ. 1.90 3.0 2.0 700 20 ±55 80 80 Max. 2.30 10 - Unit V µA mW mW/sr nm nm deg. ns ns * Total Radiated Power is measured by Photodyne #500 Notes • Do not view directly into the emitting area of the LED during operation! • The above specifications are for reference purpose only and subjected to change without prior notice. 14.11.2013 SMC700 1 of 2 Soldering Conditions • • • DO NOT apply any stress to the lead particularly when heat. After soldering the LEDs should be protected from mechanical shock or vibration until the LEDs return to room temperature. When it is necessary to clamp the LEDs to prevent soldering failure, it is important to minimize the mechanical stress on the LEDs. Temperature Profile PCB Footprint Layout (Unit: mm) Static Electricity • LEDs are very sensitive to Static Electricity and surge voltage. It is recommended to always wear a wrist band or an anti-electrostatic glove when handling the LEDs. • All devices, equipment and machinery must be grounded properly. It is recommended that precautions should be taken against surge voltage to the equipment that mounts the LEDs. 14.11.2013 SMC700 2 of 2