rf amplifier model tm7212pm

RF AMPLIFIER
MODEL TM7212PM
Available as:
Features
!
!
!
!
Maximum Ratings
Superior Phase Noise Performance
Low Noise Figure: 1.8 dB Typical
Lower +12 Vdc Supply
Operating Temp. -55 ºC to +85 ºC
Specifications
CHARACTERISTIC
Frequency
Gain (dB)
Power @ 1 dB
Comp. (dBm)
Reverse
Isolation (dB)
TYPICAL
Ta= 25 ºC
10 - 200 MHz
8.5
MIN/MAX
Ta = -55 ºC to +85 ºC
30 - 200 MHz
7.5 Min.
+20
+19 Min.
-12
-11 Max.
In
Out
Noise Figure (dB)
<1.75:1
<1.35:1
1.8
2.0:1 Max.
2.0:1 Max.
3.0 Max.
Power
+12
30
+12
33 Max.
VSWR
Vdc
mA
TM7212PM, 4 Pin TO-8 (T4)
TN7212PM, 4 Pin Surface Mount (SM3)
FP7212PM, 4 Pin Flatpack (FP4)
BX7212PM, Connectorized Housing (H1)
Ambient Operating Temperature.................-55ºC to +100 ºC
Storage Temperature.................................-62ºC to +125 ºC
Case Temperature..................................................+125 ºC
DC Voltage..........................................................+15 Volts
Continuous RF Input Power...................................+15 dBm
Short Term RF Input Power...... 50 Milliwatts (1 Minute Max.)
Maximum Peak Power.................... 0.5 Watt (3 µsec Max.)
Thermal Resistance (Theta J C) ....................... 81 ºC/Watt
Junction Temperature Rise Above the Case Temp........+24ºC
Maximum Operating Junction Temperature...............+109ºC
Maximum Junction Temperature of Die.....................+205ºC
MTBF Calculation for Ground Benign Environment
@ 25 ºC .................................................4,067,101.04 hrs
Guaranteed Phase Noise Performance (dBc/Hz)
Note: Care should always be taken to effectively ground the case of each unit.
Typical Intermodulation Performance at 25 ºC
Second Order Harmonic Intercept Point ....... +61 dBm (Typ.)
Second Order Two Tone Intercept Point ........ +55 dBm (Typ.)
Third Order Two Tone Intercept Point ............ +40 dBm (Typ.)
Frequency
100 Hz
1 kHz
10 kHz
100 kHz
1 MHz
Typical
-172
-178
-180
-181
-179
Guarantee (Min.)
-168
-174
-176
-177
-175
Typical Performance Data
Gain (dB)
0
10
9
-5
8
-10
7
-15
Reverse Isolation (dB)
-140
-150
-160
-20
6
Start 30 MHz
Stop 200 MHz
Start 30 MHz
Stop 200 MHz
Noise Figure (dB)
1 dB Comp. (dBm)
+23
Phase Noise (dBc/Hz)
-130
3
+22
-170
-180
2
+21
-190
100
+20
1
+19
Start 30 MHz
2.0
Input VSWR
Start 30 MHz
Stop 200 MHz
Stop 200 MHz
Output VSWR
2.0
1.5
1.5
1.0
1K
10K
100K
1M
_________Guarantee __ __ __ __Typical
Phase Noise Test Conditions:
Carrier Frequency: 100 MHz
Power Output: +20 dBm
Temperature: 25 ºC
Agilent ES5500 System
1.0
Start 30 MHz
Legend
Stop 200 MHz
+25 ºC
Start 30 MHz
Stop 200 MHz
+85 ºC - - - - - - -55 ºC
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532
Rev.
3/12/09
www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001