Available as: RF AMPLIFIER MODEL TM5325PM TM5325PM, 4 Pin TO-8 (T4) TN5325PM, 4 Pin 0.450” Surface Mount (SM3) PN5325PM, 4 Pin 0.375” Sq. Surface Mount (SM11) FP5325PM, 4 Pin 0.500” Sq. Flatpack (FP4) BX5325PM, SMA Connectorized Housing (H1) Features Typical Intermodulation Performance at 25 ºC Second Order Harmonic Intercept Point ....... +58 dBm (Typ.) Second Order Two Tone Intercept Point ........ +52 dBm (Typ.) Third Order Two Tone Intercept Point ............ +40 dBm (Typ.) Superior Phase Noise Performance Low Noise Figure: 2.0 dB Typical High Output Power: +24 dBm Typical Operating Temp. -55 ºC to +85 ºC Absolute Maximum (No Damage) Ratings Specifications CHARACTERISTIC Ambient Operating Temperature ................ -55ºC to +100 ºC Storage Temperature ................................. -62ºC to +125 ºC Case Temperature .................................................. +125 ºC DC Voltage .......................................................... +18 Volts Continuous RF Input Power .................................. +13 dBm Short Term RF Input Power ...... 50 Milliwatts (1 Minute Max.) Maximum Peak Power .................... 0.5 Watt (3 μsec Max.) TYPICAL Ta= 25 ºC 5 - 125 MHz MIN/MAX Ta = -55 ºC to +85 ºC 10 - 100 MHz Gain (dB) Power @ 1 dB Comp. (dBm) Reverse Isolation (dB) 20.5 20.5 + 1.0 +24 +22.5 Min. -24 -23 Max. Frequency VSWR 1.70:1 1.35:1 2.0 2.2:1 Max. 2.0:1 Max. 3.0 Max. +12 85 +12 95 Max. 100 Hz 1 kHz 10 kHz 100 kHz 1 MHz Frequency Guaranteed Phase Noise Performance (dBc/Hz) In Out Noise Figure (dB) Power Vdc mA Typical -170 -175 -175 -176 -175 Guarantee (Min.) -166 -171 -171 -172 -171 Note: Care should always be taken to effectively ground the case of each unit. Revision: 2/11/2015 Typical Performance Data Gain (dB) 22 0 21 -10 20 -20 19 -30 18 Start 10 MHz Stop 100 MHz 1 dB Comp. (dBm) +26 -40 Reverse Isolation (dB) -130 -140 -150 Start 10 MHz Stop 100 MHz Noise Figure (dB) 3.0 +25 -160 -170 -180 2.0 +24 -190 100 +23 +22 Start 10 MHz Stop 100 MHz 1.0 Start 10 MHz Stop 100 MHz Output VSWR Input VSWR 2.0 1.5 Start 10 MHz Legend Stop 100 MHz +25 ºC 1.0 Start 10 MHz 1K 10K 100K __ __ __ __Typical Phase Noise Test Conditions: Carrier Frequency: 100 MHz Power Output: +24 dBm Temperature: 25 ºC Agilent ES5500 System 2.0 1.5 1.0 Phase Noise (dBc/Hz) Stop 100 MHz +85 ºC - - - - - - -55 ºC Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001 1M