TOCOS ® TP96N93 Series PA N E L C O N T R O L S Long Life 9mm Square, Single-Turn, Carbon Panel Controls TP96N93 TP96N238 Features Long life 9mm square, single-turn industrial panel controls Carbon film element Up to 300,000 cycle rotational life Single unit, single shaft Internal resin molded coating to prevent flux intrusion Metal shaft and bushing Linear taper Standard 15mm or 20mm shaft length 6mm diameter shafts in slot, flat or round end styles Standard PCB right angle inline pin terminals Vertical mount pin terminals available as special order Specifications Electrical Environmental Standard Resistance Range . . . . . . . . . . . . . 1kΩ to 100kΩ Temperature Range . . . . . . . . . . . . . . . . . . 20C to 70C Resistance Tolerance . . . . . . . . . . . . . . . . . 20% standard Temperature Characteristics . . . . . . . . . 70C, 240 hours ∆T/R )5%,30% End Resistance . . . . . . . . . . . . . . . . . . . . . . . . . . 100Ω max. Resistance Taper . . . . . . . . . . . . . . . . . . . . . . . . . . B = linear Peak Noise (C.R.V.) . . . . . . . . . . . . . . . . . . . . . . 100mV max. Power Rating . . . . . . . . 0.05 watt at 50C, 0 watt at 70C Maximum Input Voltage . . . . . . . . . 70VDC or power rating, whichever is smaller Insulation Resistance . . . . . . . 100MΩ minimum at 250VDC Dielectric Strength . . . . . . . . . . . . . . . . . . 300VAC, 1 minute Temperature Cycle . . . . . . . . . . . . . . . . . . . . 20C ,70C, 30 minutes each, 5 cycles ∆T/R )10%,30% Load Life . . . . . . . . . . . . . . . . 50C, 0.05 watt, 1,000 hours ∆T/R )30% Moisture and Load Life . . . . . . . . . . . . 40C, 90-95%RH, 0.05 watt, 350 hours ∆T/R )20% Adjustment Travel . . . . . . . . . . . . . . . . . . . . . . 266 nominal Vibration . . . . . . . . .10-55Hz, 1.5mm amplitude, 3 directions ∆T/R )2.5% Mechanical Soldering Heat Resistance . . . . . . . 350C5C, 5 seconds ∆T/R )5% Mechanical Travel . . . . . . . . . . . . . . . . . . . . . . . . . . 3005 Shaft Torque . . . . . . . . . . . . . . . 20 gf • cm (0.277 oz • in) max. Rotational Life . . . . . . . . . . . 300,000 cycles with 3.5V load ∆T/R )15% Stop Strength . . . . . . . . . . . . . . 5 kgf • cm (69.31 oz • in) min. ∆T/R = Total Resistance Change Shaft Strength (push) . . . . . . . . . . . . . . 98.1 N (10 kgf ) min. Shaft Strength (tensile) . . . . . . . . . . . . . 98.1 N (10 kgf ) min. Shaft End Play . . . . . . . . 0.5(shaft length/30) mm max. Mounting Nut Torque . . . . . . 10 kgf • cm (138.63 oz • in) min. Marking . . . . . . . . . . . . . Model type, taper, resistance code, terminal identification, date code Note: A long life panel control should only be used in a circuit as a potentiometer (3-terminal voltage divider ). TOCOS AMERICA, INC. 84 1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 E-mail: [email protected] Unit: mm www.tocos.com TP96N93 Series Dimensions TP96N93 Unit: mm PCB Mount, Single Unit, Single Shaft Right Angle Mount Pin Terminals, 3-Pin Inline Pattern Recommended Panel Mounting Holes Part Numbering System TP 9 6 N 93 15 S B 104 M NOTE: FMS = From Mounting Surface Resistance Tolerance: M = 20% (standard). Resistance Code: Expressed in ohms. A three digit code where the first two digits are significant figures, and the third digit indicates the number of zeros that follow these figures (i.e., 100 = 10Ω; 101 = 100Ω; 102 = 1,000Ω; 103 = 10,000Ω; 104 = 100,000Ω ). See table for standard resistance values. Resistance Taper: B = Linear. Shaft End Style: S = Slotted. F = Flatted. R = Round. Standard Shaft Length: 15 = 15 mm FMS. 20 = 20mm FMS. Up to 50mm shaft length available (special order ). Rotational Life: 93 = Long Life, 300,000 cycles. Q = Long Life, 100,000 cycles (special order ). Style: N = PCB Mount, Single Unit, Single Shaft, Pin Terminals, 3-Pin Inline Pattern. Mechanical Travel: 6 = 300 Mechanical Travel. Size: 9 = 9mm. TOCOS Series Name: TP = PCB Pin Terminals, Right Angle Mount. RH = PCB Pin Terminals, Vertical Mount (available as special order ). Standard Resistance Values and Part Numbering Codes Standard Nominal Total Resistance Values and Part Numbering Codes Resistance ( Ω ) Code Resistance ( Ω ) Code Resistance ( Ω ) Code 1,000 2,000 5,000 102 202 502 10,000 20,000 50,000 103 203 503 100,000 104 Refer to Shaft End Styles Specifications and Hardware Specifications for details and availability. For additional information, refer to Guidelines and Precautions for Using Panel Controls. TOCOS AMERICA, INC. 1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 85 E-mail: [email protected] www.tocos.com