CENTER PIN / JACK SIZE MATING POWER PLUG L712RAS 0.10 [2.5 mm] 761KS12, 761KS15, 761KS17 L722RAS 0.08 [2.0 mm] S761KS12, S761KS15, S761KS17 767KS12, 767KS15, 767KS17 PART NUMBER PANEL MOUNT SEAL O-RING MATING PLUG SEAL O-RING 0.610 15.48 FLAT WASHER 0.220±0.002 5.59±0.05 HEX NUT 7/16-32 UN THREAD CENTER PIN 0.130±0.002 3.30±0.05 (SEE NOTE 1) SLEEVE 1.03 26.3 CENTER PIN/JACK SIZE (SEE TABLE) MTG SURFACE OF BUSHING 0.37 9.4 0.63 15.9 0.130±0.002 3.30±0.05 (SEE NOTE 1) 0.067±0.001 1.70±0.03 TYP 0.65 16.5 SLEEVE SHUNT RECOMMENDED PCB LAYOUT (COMPONENT SIDE) 0.330 8.38 7/16-32 UN - 2A THREAD MAXIMUM PANEL THICKNESS 0.090 2.29 0.14 3.6 0.390 9.9 0.610 15.5 0.440±0.002 11.18±0.05 CENTER PIN SLEEVE SHUNT SLEEVE CENTER PIN SLEEVE SHUNT SLEEVE NOTES: RECOMMENDED PANEL MTG HOLE SCHEMATIC 1. FOR HAND INSERTION USE SPACING 0.130 [3.30] FOR AUTOMATED INSERTION USE SPACING 0.135 [3.43] CUSTOMER DRAWING THIS DRAWING DESCRIBES A DESIGN CONSIDERED PROPRIETARY IN NATURE, DEVELOPED AND MANUFACTURED BY SWITCHCRAFT INC. AND IS RELEASED ON A CONFIDENTIAL BASIS FOR IDENTIFICATION PURPOSES ONLY. 2. DIMENSIONS SHOWN FOR REFERENCE ONLY. 3. HEX NUT, FLAT WASHER, AND PANEL O-RING SUPPLIED UNASSEMBLED 4. MATERIAL: HOUSINGS, HEX NUT - COPPER ALLOY, NICKEL PLATED INSULATOR HOUSING - THERMOPLASTIC O-RINGS - NEOPRENE RUBBER, LUBRICATED WITH SYNTHETIC GREASE TERMINAL INSULATORS - PHENOLIC FLAT WASHER - STEEL, NICKEL PLATED PIN, SPRING, TERMINALS - COPPER ALLOY, SILVER PLATED 5. THIS PRODUCT IS RoHS COMPLIANT UNLESS OTHERWISE SPECIFIED 1. ALL DIMENSIONS IN INCHES SIZE WIDTH FINISH - TWO PLACE DECIMALS 0.02 - THREE PLACE DECIMALS 0.005 SPEC No. FIRST USED ON 27029 10/01/12 BL TJK DATE DRAWN A 26591 8/6/10 RS TJK 7/23/09 ECO NUMBER DATE REVISIONS BY APVD DO NOT SCALE DRAWING SolidWorks CAD File NAME B LBS/M TEMPER MATERIAL B REV MULT BY PNK SPEC No. SCALE 2:1 CHKD RS 8/6/10 APVD TJK 8/6/10 SEALED POWER JACKS RIGHT ANGLE PC, RoHS SHEET PART No. 1 OF 1 L712RAS, L722RAS REV B