PANDUCT PANELMAX Noise Shield For Use Mounted Separately or With PANDUIT PANDUCT Types D, F, FS, G, H, HN, and HS Wiring Duct Part Numbers: SD2EMI, SD3EMI, SD4EMI INSTALLATION INSTRUCTIONS © Panduit Corp. 2009 Sizing Noise Shield SD2EMI, SD3EM1, SD4EMI ANTI-OXIDIZING COMPOUND (supplied in Kit) Option 1 - Noise Shield Mounted Seperately 1 Panel surface must be prepared prior to mounting Noise Shield to achieve electrical bond (see back page) - or - 2 Installer/end user supplied hardware Note: #10-32x1/2” (or sheet metal screw equivalent) to be supplied by the installer/end user 2” MAX -2 and - or - Note: #10 Flat Washer and #10 Lock Washer to be supplied by the installer/end user For Technical Assistance, Call: 800-777-3300 INSTALLATION INSTRUCTIONS Option 2 - Noise Shield Mounted with Duct 1 SD2EMI, SD3EM1, SD4EMI Panel surface must be prepared prior to mounting Noise Shield to achieve electrical bond (see back page) ANTI-OXIDIZING COMPOUND (supplied in Kit) 2 BONDING CLIP (supplied in Kit) 2” MAX -2 - or - 3 Note: #10-32x1/2” (or sheet metal screw equivalent) to be supplied by the installer/end user Installer/end user supplied hardware Maximum Hole Spacing 12 Duct installed with Installer/end user supplied hardware Screws or NR1-C Rivets and - or - Note: #10 Flat Washer and #10 Lock Washer to be supplied by the installer/end user For Technical Assistance, Call: 800-777-3300 INSTALLATION INSTRUCTIONS Recommended Wiring and Labeling Practices Option for Additional Abrasion Protection OPTIONAL: GROMMET EDGE (SOLD SEPARATELY) RECOMMENDED: GEE36-F GEE36FA-C Do not use excessive tension when fastening cable ties. Apply cable ties loosely to Ethernet Cabling. CABLE TIES USED TO RETAIN CABLES (SOLD SEPARATELY) RECOMMENDED: ELASTOMERIC: ERT 2/3/4.5M TAK TY: HLT2I TAK TAPE: TTS HOOK AND LOOP STRIPS: HLS AND UCT PLASTIC: PLT- M, -I, OR -S BARB TY: BT-M, -I, OR -S CBR Option for Identifying the Noise Shield and Location/Side of Noise. Applied to Noise Shield or Panel Surface. NOISE SHIELD PANEL IDENTIFICATION LABEL (SUPPLIED IN KIT) For Technical Assistance, Call: 800-777-3300 INSTALLATION INSTRUCTIONS Surface Preperation For Good Electrical Bond Location of Bonds should be within 2” of Both Shield Ends 1 Remove paint or Oxidation to bare metal. 80 to 150 grit sandpaper, recommended (User Supplied) 2 Cover Sanded Area with Anti-Oxidizing Compound (supplied in kit) 2” MAX 2” MAX 1 Noise Shield Sanding Template 2 Noise Shield within Duct Sanding Template 3/4 2-5/8 Instruction Sheet RW260 WORLDWIDE SUBSIDIARIES AND SALES OFFICES 17301 Ridgeland Avenue Tinley Park, IL 60477-3901 Web Site: www.panduit.com Fax: 708-532-1811 Technical Support: 800-777-3300 RACEWAY SYSTEMS DIVISION