PRODUCT DATASHEET SP-TELCO TELEPHONE LINE SURGE AND LIGHTNING PROTECTOR Surge Protectors Save Equipment and Money Telephone lines are one of the most common entry points for voltage surges from lightning strikes or other sources. These surges can easily damage or completely destroy your expensive communications equipment. The solution is simple – install an inexpensive surge suppressor on each telephone device. PRODUCT HIGHLIGHTS Advanced 3 stage hybrid protection Save money on repair and replacement Modular and compact design DIN rail or direct panel mounting Protective grounding to DIN rail UL and CE rated for industrial use Compatible with Sixnet’s industrial telephone modems Protects: PERFORMANCE SPECIFICATIONS Solid state sidactors with fast acting fuses and resistors Usage: telephone lines Ports protected: 1 (2 lines per port) Connectors: RJ11 (pins 3, 4) Surge capacity: 1.9 kA / line Clamp and rated: 270 V and 200 V Max. frequency: 50 MHz Operating temp.: -40 to +85 oC Max inline resistance: 22 Ohm Ratings: UL 497A, IEC801-5, CCITT K17 Internal or external modems or any 2-wire telephone line device MECHANICAL DRAWING 4.05” Side View 2.25” 5.10” INSTALLATION INSTRUCTIONS 1. Snap to DIN rail or screw to panel. Make sure DIN rail is grounded. Use grounding kit if direct panel mounting. 2. Correct grounding is essential. Minimize distance from protector to ground point which should be common with AC GND. 3. Connect “unprotected” port to incoming line. Use supplied cable to connect “protected” port to device to be protected. 4. Important notes: Always use supplied patch cable. Ground leads should be 14AWG or larger and less than 12”. Top View 1.00” Direct Panel Grounding 4.55” Bottom View 0.198 Dia. All specifications are subject to change. Consult factory for latest info. ORDERING GUIDE SP-TELCO-1 SP-TELCO-1-5 Phone line protector (1 piece) Phone line protector (5 pack) Notes: Each protector supplied with a grounding kit for direct panel mounting and one telephone patch cable. Units are installed inline and identified with “protected’ and “unprotected” to provide failsafe installations. DIN Mounting Sixnet Technology Park 331 Ushers Road • Ballston Lake, NY 12019 • USA 1.518.877.5173 • Fax 1.518.877.8346 • [email protected] SOLUTIONS FOR YOUR INDUSTRIAL NETWORKING CHALLENGES Datasheet SP-TELCO Rev. July, 15 2009 WWW.SIXNET.COM