Model 7233 BNC (M) 75 Ω Crimp, C/S0222, Belden 8218, YR23023 Ordering Information Model: 7233, BNC (M) 75 Ω, COMM/SCOPE 0222, Belden 8218, Belden YR23023 . Model 7233 BNC (M) 75 Ω Crimp Belden 8218 Use for your 75 Ω broadcast applications and cable assemblies. Features • True 75 Ω. • Designed for common Belden cables (see table on page 2 for cable types and crimp die information). • Precision machined. • Gold-plated (15 micro–inches) contacts. • Insulation material is PTFE (not delrin). Materials • Body is machined brass with tarnish resistant nickel plating. • Male center pin contacts are gold plated (15 micro-inches) brass. High quality machined PTFE dielectric. • USA: Sales: 800-490-2361 Technical Support: 800-2412060 Fax: 888-403-3360 Europe: 31-(0) 40 2675 150 International: 425-446-5500 e-mail: [email protected] Where to Buy: www.pomonaelectronics.com See page 2 for cable type, crimp information and cable assembly instructions. Specifications Nominal impedance 75 Ω Frequency 0-3 GHz VSWR 1.10 max. 0-3 GHz Center / Outer contact resistance 1.5 / 1.0 mΩ Number of insertions 500 Insulation resistance 5000 MΩ (min) Dielectric withstand voltage 1500 Vrms Ratings: Voltage: 500 Vrms Operating temperature: -85 ˚F to +131 ˚F (-65 ˚C to +155 ˚C) Max. All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Copyright © 2004 10/2004 2401565 D-ENG-N Rev A Page 1 of 2 Model 7233 BNC (M) 75 Ω Crimp, C/S0222, Belden 8218, YR23023 Connector Model # 7233 Cable Groups COMM/SCOPE 0222, Belden 8218, Belden YR23023 Crimp Die set* Size (Hex/Pin) Model 7285 (.178 / .042) Cable Type and Crimp Die Set Information *For use with Pomona Crimp Tool Model 7277. Cable Assembly Instructions USA: Sales: 800-490-2361 Technical Support: 800-2412060 Fax: 888-403-3360 Europe: 31-(0) 40 2675 150 International: 425-446-5500 e-mail: [email protected] Where to Buy: www.pomonaelectronics.com All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Copyright © 2004 10/2004 2401565 D-ENG-N Rev A Page 2 of 2