UNISONIC TECHNOLOGIES CO., LTD TA2003 Preliminary LINEAR INTEGRATED CIRCUIT AM/FM RADIO IC DESCRIPTION The UTC TA2003 is AM/FM Radio IC (FM F/E + AM/FM IF) which is designed for AM/FM Radios. DIP-16 FEATURES * FM IFT, AM IFT and FM Detector Coil are unnecessary. * Operating Supply Voltage Range * VCC(opr) = 1.8 ~ 7V ( Ta=25C) SOP-16 ORDERING INFORMATION Ordering Number Lead Free TA2003L-D16-T - Halogen Free TA2003G-D16-T TA2003G-S16-R Package Packing DIP-16 SOP-16 Tube Tape Reel MARKING DIP-16 www.unisonic.com.tw Copyright © 2014 Unisonic Technologies Co., Ltd SOP-16 1 of 7 QW-R110-011.C TA2003 Preliminary LINEAR INTEGRATED CIRCUIT EXPLANATION OF TERMINAL Terminal Voltage: Typical DC voltage at TA=25C, VCC=3V and no signal with Test Circuit PIN PIN NAME DESCRIPTION INTERNAL CIRCUIT NO. 1 FM AF IN 2 GND1 3 FM MIX 4 AM MIX TERMINAL VOLTAGE Input of FM RF Amplifier 0 0.7 GND for RF, DSC and MIX Stage 0 0 Output of FM MIX 0.4 1.7 Output of AM MIX 0.6 0 0 0 3.0 3.0 3.0 3.0 3.0 3.0 IF AGC 5 5 AGC AGC By pass of AM AGC RF AGC GND2 6 VCC 7 AM IF IN 8 FM IF IN Input of AM IF Amplifier Input of FM IF Amplifier UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 9 2 of 7 QW-R110-011.C TA2003 PIN NO. 9 Preliminary LINEAR INTEGRATED CIRCUIT EXPLANATION OF TERMINAL PIN NAME GND2 DESCRIPTION INTERNAL CIRCUIT GND for IF stage VCC 10 QUAD TERMINAL VOLTAGE 0 0 6 FM QUAD Detector Ceramic Discriminator is connected. Recommendation CDA 10.7MG31 (MURATA MFG. CO., LTD) 10 GND2 2.5 2.2 9 11 DET OUT Output of FM/AM Detector 1.4 1.1 12 AM OSC AM local Oscillator Terminal Oscillator Coil is connected. 3.0 3.0 13 FM OSC FM local Oscillator Terminal Oscillator Coil is connected 0.9 3.0 14 AM/FM SW AM/FM switch connected to Pin14 VCC→FM mode Pin14 OPEN→AM mode 0.9 3.0 15 FM RF OUT FM RF Coil is connected 3.0 3.0 16 AM RF IN Input of AM RF Amplifier 3.0 3.0 cf. PIN 1 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 7 QW-R110-011.C TA2003 Preliminary LINEAR INTEGRATED CIRCUIT BLOCK DIAGRAM UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 7 QW-R110-011.C TA2003 Preliminary LINEAR INTEGRATED CIRCUIT ABSOLUTE MAXIMUM RATING (TA=25C, unless otherwise specified) PARAMETER SYMBOL VCC RATINGS UNIT 8 V DIP-16 750 Power Dissipation PD mW SOP-16 350 Operating Temperature TOPR -25 ~ 75 C Storage Temperature TSTG -55 ~ 150 C Notes: 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. 2. On PCB (Test Board: JEDEC 2s2p) Supply Voltage ELECTRICAL CHARACTERISTICS Unless otherwise specified, TA=25C, VCC=3V, FE: f = 98MHz, fm = 1KHz, FM IF: f = 10.7MHz, △f=±22.5kHz, fm = 1KHz AM: f = 1MHz, MOD = 30%, fm = 1 KHz PARAMETER Supply Current Input Limiting Voltage SYMBOL TEST CONDITIONS MIN TYP MAX UNIT 16.5 8.0 mA ICC (FM) ICC (AM) FM Mode, Vin=0 AM Mode, Vin=0 10.5 5.0 Vin (lim) -3dB limiting point 12 S/N=30dB 12 F/E Quiescent Sensitivity QS Local OSC Voltage Local OSC Stop Voltage VOSC Vstop (FM) fOSC=108MHz Vin=0 160 240 1.2 320 Input Limiting Voltage Vin(lim)IF -3dB limiting point 42 47 52 FM Recovered Output Voltage IF Signal To Noise Ratio Total Harmonic Distortion AM Rejection Ratio Voltage Gain Recovered Output Voltage AM Signal To Noise Ratio Total Harmonic Distortion Local OSC Stop Voltage VOD S/N THD AMR GV VOD S/N THD Vstop (AM) Vin=80dBμV EMF Vin=80dBμV EMF Vin=80dBμV EMF Vin=80dBμV EMF Vin=27dBμV EMF Vin=60dBμV EMF Vin=60dBμV EMF Vin=60dBμV EMF Vin=0 50 70 62 0.4 33 32 60 43 1.0 1.6 90 15 35 50 85 dBμV EMF dBμV EMF mVrms V dBμV EMF mVrms dB % dB mVrms mVrms dB % V TEST CIRCUIT 1 1 1 1 2 2 1 1 1 1 1 1 1 1 1 1 COIL DATA (TEST CIRCUIT) COIL NO. L1 FM RF L2 FM OSC L3 AM OSC TEST FREQ (Hz) 100M 100M 796K L (μH) CO (pF) 268 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw QO 100 100 125 1-2 2-3 14 86 TURNS 1-3 1.75 1-4 2.25 4-6 WIRE (mm ) 0.5 UEW 0.5 UEW 0.06 UEW 5 of 7 QW-R110-011.C TA2003 Preliminary LINEAR INTEGRATED CIRCUIT TEST CIRCUIT1 - DET OUT 2.2uF + AM 4.7nF 47nF 20kΩ FM 1kΩ - 220uF + 15pF 0.01uF 75Ω L3 L2 L1 75Ω 330pF FM 0.022uF CDA10.7MG31 2.2kΩ 2.2 mH AM RF IN AM 0.01uF VCC Vin 16 AM RF IN 15 FM RF OUT 14 FM/AM SW AM/ FM SW 13 FM OSC FM OSC 12 AM OSC 11 DET OUT AM OSC 10 QUAD 9 GND2 FM DET AM RF AM DET FM RF IN FM RF FM MIX AM MIX AGC 75Ω 1 FM RF IN GND1 2 FM MIX 3 4 FM IF AM IF BPF AM MIX AGC 5 Vcc 6 7 AM IF IN 8 FM IF IN SFE10.7MA5L SFU455C5 SFE10.7MA5L 75Ω FM IF IN 33uF Vin 270Ω Vin 220uF 2.2kΩ 15pF 100uF 0.01uF 0.01uF TEST CIRCUIT2 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 6 of 7 QW-R110-011.C TA2003 Preliminary LINEAR INTEGRATED CIRCUIT UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 7 of 7 QW-R110-011.C