UNISONIC TECHNOLOGIES CO., LTD DTC123J NPN SILICON TRANSISTOR NPN DIGITAL TRANSISTOR (BUILT-IN RESISTORS) FEATURES * Built-in bias resistors enable the configuration of an inverter circuit without connecting external input resistors (see equivalent circuit). * The bias resistors consist of thin-film resistors with complete isolation to allow negative biasing of the input. They also have the advantage of almost completely eliminating parasitic effects. * Only the on/off conditions need to be set for operation, making device design easy. EQUIVALENT CIRCUIT ORDERING INFORMATION Ordering Number Lead Free Halogen Free DTC123JG-AE3-R DTC123JG-AL3-R DTC123JG-AN3-R DTC123JG-AL6-T DTC123JG-AL6-R DTC123JL-T92-K DTC123JG-T92-K DTC123JL-T92-B DTC123JG-T92-B DTC123JL-T9S-K DTC123JG-T9S-K DTC123JL-T9S-B DTC123JG-T9S-B Note: Pin Assignment: G: GND I: IN O: OUT www.unisonic.com.tw Copyright © 2015 Unisonic Technologies Co., Ltd Package SOT-23 SOT-323 SOT-523 SOT-363 SOT-363 TO-92 TO-92 TO-92SP TO-92SP Pin Assignment 1 2 3 G I O G I O G I O G I O G I O G O I G O I G O I G O I Packing Tape Reel Tape Reel Tape Reel Tube Tape Reel Bulk Tape Box Bulk Tape Box 1 of 4 QW-R206-076.I DTC123J NPN SILICON TRANSISTOR MARKING SOT-23 / SOT-323 / SOT-523 SOT-363 6 5 4 CC3J 1 TO-92 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 3 TO-92SP 2 of 4 QW-R206-076.I DTC123J NPN SILICON TRANSISTOR ABSOLUTE MAXIMUM RATINGS (TA=25°C, unless otherwise specified) PARAMETER Supply Voltage Input Voltage Output Current Power Dissipation SYMBOL VCC VIN IO IC(MAX.) SOT-23/SOT-323 SOT-363 SOT-523 TO-92 TO-92SP RATINGS 50 -5 ~ +12 100 100 UNIT V V mA 200 mW 150 625 550 Junction Temperature TJ 150 °C Storage Temperature TSTG -55 ~ +150 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. PD ELECTRICAL CHARACTERISTICS (TA=25°C, unless otherwise specified) PARAMETER SYMBOL VI (OFF) Input Voltage VI (ON) Output Voltage VO (ON) Input Current II Output Current IO(OFF) DC Current Gain hFE Input Resistance R1 Resistance Ratio R2/R1 Transition Frequency fT Note: Transition frequency of the device TEST CONDITIONS VCC=5V, IO=100μA VO=0.3V, IO=5mA IO/II =5mA/0.25mA VI =5V VCC=50V, VI =0V VO=5V, IO=10mA VCE =10V, IE=−5mA, f=100MHz (Note) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN 1.1 80 1.54 17 TYP MAX UNIT 0.5 V 0.1 0.3 3.6 0.5 V mA μA 2.2 21 250 2.86 26 KΩ MHz 3 of 4 QW-R206-076.I DTC123J Input Current, IIN (µA) Output Current, IOUT (µA) TYPICAL CHARACTERISTICS 100 90 R2 1000 80 70 60 50 40 30 20 10 0 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 GND(+) Voltage, VGND(+) (V) DC Current Gain vs. Output Current 500 VIN=0V, OUT OPEN DC Current Gain, hFE GND(+) Current, IGND(+) (µA) NPN SILICON TRANSISTOR 200 100 50 VOUT=5V TA= 100°C 25°C -40°C 20 10 5 2 1 0.1 0.2 0.5 1 2 5 10 20 50 100 Output Current, IOUT(mA) UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 4 QW-R206-076.I