SFS1575D-LF Rev A1 Fixed Frequency Synthesizer Surface Mount Module Applications Application Notes • GPS Clock • Test Equipment • • AN-107: Manual Soldering Technique • AN-205: Measuring Phase Noise for SFS Series Performance Specifications Frequency Min Typ 1575.42 Max Units 1575.42 MHz Phase Noise @ 10 kHz offset (1 Hz BW) -102 dBc/Hz Harmonic Suppression (2nd) -18 dBc Spurious Suppression -70 dBc Power Output 2 5 Load Impedance 50 Settling Time 3 Operating Temperature Range -40 Package Style 8 dBm mS 85 °C PLL-V12N Power Supply Requirements Min Typ Max Units Supply Voltage 1: PLL (Vcc, nom) 3.0 3 3.5 Vdc Supply Voltage 2: VCO (Vcc, nom) 4.80 5 5.15 Vdc Supply Current 1: PLL (Icc, typ) 14 mA Supply Current 2: VCO (Icc, typ) 20 mA Reference Oscillator Signal Frequency Phase Noise @1 kHz Offset Min Typ Max Units 10 MHz -145 dBc/Hz Additional Notes LFSuffix = RoHS Compliant. All specifications are subject to change without notice. © Z-Communications, Inc. All Rights Reserved. 14118 Stowe Drive, Suite B | Poway, CA 92064 | TEL: (858) 621-2700 | FAX: (858) 486-1927 URL: www.zcomm.com | EMAIL: [email protected] Page 1 of 2 FRM-S-002 B Fixed Frequency Synthesizer Surface Mount Module SFS1575D-LF Rev A1 Phase Noise, typ. Footprint PHASE NOISE (1 Hz BW, typical) RECOMMENDED FOOTPRINT £(f) (dBc/Hz) SEVERAL HOLES OF O 0.015 ON GND. PLANE ARE RECOMMENDED FOR GOOD GROUNDING. 0.030 MIN. CUTBACK FROM LIVE PADS OFFSET (Hz) Physical Dimensions ALL DIMENSIONS ARE IN INCHES TOL : XXX: +/- 0. 010 SFS PIN CONFIGURATION 1 Vcc (VCO) 3 RF OUT 5 MUX OUT 6 Vcc (CHIP) 1 12 2 11 3 4 5 6 Z-COMM X XX X XXXX-LF W/O# D/C NOTE : 10 9 8 7 LFSuffix = RoHS Compliant. All specifications are subject to change without notice. © Z-Communications, Inc. All Rights Reserved. URL: www.zcomm.com | EMAIL: [email protected] 8 10 N/C REF IN REST GROUND PVA PIN CONFIGURATION 1 Vcc ( VCO) 3 RF OUT 5 MUX OUT 6 Vcc (CHIP) 7 CLOCK 8 DATA 9 ENABLE REF IN 10 REST GROUND Page 2 of 2 FRM-S-002 B