SFS13500Z-LF Rev A1 Fixed Frequency Synthesizer Surface Mount Module Applications Application Notes • Broadband transmission • Microwave Radio • Performance Specifications Frequency • AN-107: Manual Soldering Technique • AN-205: Measuring Phase Noise for SFS Series Min Typ 13500 Max Units 13500 MHz Phase Noise @ 10 kHz offset (1 Hz BW) -80 dBc/Hz Harmonic Suppression (2nd) -30 dBc Spurious Suppression -65 dBc Power Output -3 0 Load Impedance 50 Settling Time 0.5 Operating Temperature Range -40 Package Style 3 dBm mS 85 °C SFS-L2 Power Supply Requirements Min Typ Max Units Supply Voltage 1: PLL (Vcc, nom) 3.0 3 3.5 Vdc Supply Voltage 2: VCO (Vcc, nom) 4.80 5 5.15 Vdc Supply Current 1: PLL (Icc, typ) 11 mA Supply Current 2: VCO (Icc, typ) 90 mA Reference Oscillator Signal Frequency Phase Noise @1 kHz Offset Min Typ Max Units 10 MHz -145 dBc/Hz Additional Notes PIN 13 ( -5.0 V) MUST BE APPLIED PRIOR TO ADDING PIN 24 & PIN 26 LFSuffix = RoHS Compliant. All specifications are subject to change without notice. © Z-Communications, Inc. All Rights Reserved. 14118 Stowe Drive, Suite B | Poway, CA 92064 | TEL: (858) 621-2700 | FAX: (858) 486-1927 URL: www.zcomm.com | EMAIL: [email protected] Page 1 of 2 FRM-S-002 B Fixed Frequency Synthesizer Surface Mount Module SFS13500Z-LF Rev A1 Phase Noise, typ. Footprint PHASE NOISE (1 Hz BW, typical) RECOMMENDED FOOTPRINT £(f) (dBc/Hz) SEVERAL HOLES OF O0.015 ON GND. PLANE ARE RECOMMENDED FOR GOOD GROUNDING. 0.030 MIN. CUTBACK FROM LIVE PADS OFFSET (Hz) Physical Dimensions 7 6 5 4 3 2 1 PIN CONFIGURATION 28 8 9 10 11 12 13 14 Z-COMM SFSXXXXX W/O# D/C 15 16 17 18 19 20 27 26 25 24 23 22 6 8,9 11 12 13 14 17 19 23 24 26 REST RF OUT N/C LOCK DETECT N/C -5V N/C REF IN N/C N/C Vcc CHIP Vcc VCO GROUND 21 NOTE: ALL DIMENSIONS ARE IN INCHES TOL: XXX: +/- 0.010 LFSuffix = RoHS Compliant. All specifications are subject to change without notice. © Z-Communications, Inc. All Rights Reserved. URL: www.zcomm.com | EMAIL: [email protected] Page 2 of 2 FRM-S-002 B