RK119 11mm Size Metal Shaft Reflow Type 1.5mm-travel push-on switch achieved in a low-profile height of only 5mm ■ Typical Specifications Items Specifications Total resistance tolerance ±20% Maximum operating voltage 10V DC Rotary Potentiometers Total rotational angle 10° 300°+ − 5° Slide Potentiometers Rotational torque 7.5±3.5mN・m Operating life 15,000 cycles Operating temperature range −40℃ to +85℃ Product Line Number of resistor elements Mounting direction Shaft type Total resistance Resistance Switch travel Minimum order unit(pcs.) Length of the shaft Detent taper (mm) (k Ω) L1(mm) Japan Expert Metal Shaft Without Vertical type Single-unit Flat 15 Without 10 1B 0.5 1.5 Insulated Shaft Knob Operating Ring Type 328 240 480 Products No. Drawing No. RK1191110001 1 RK1191114001 2 RK1191124001 3 Note Other varieties are also available. Refer to "Other Specifications" (P.330). Packing Specifications Tray Number of packages(pcs.) 1 case /Japan 1 case /export packing Export package measurements (mm) 240 480 240×300×270 Refer to P.330 for other specifications. Refer to P.330 for switch specifications. Refer to P.331 for ordering products not listed. Refer to P.349 for soldering conditions. RK119/11mm Size Metal Shaft Reflow Type Dimensions Photo Style Single-shaft, single-unit RK1191110001 13 ø7.825 ø7.825 112233 C1 C1 C1 Shaft shown in 15 full C.C.W position 2-2.4 2-2.4 8.2 8.5 3-2.1 4 9 Shaft shown in full C.C.W position 4 12 3 1.9 4.5 19 45 1.6 3-1.2 2-R0.8 123 5 5 4 15 4 16.5 A slant line part:The solder land Black part:Do not solder and wiring for electrical contact 5 Ring Type 13 Switch travel 1.2 ø7.825 C1 15 Shaft shown in full C.C.W position 4 5 123 15 1.6 3-1.2 2-R0.8 8.5 8.2 45 12 3 4 9 16.5 Shaft shown in full C.C.W position 4 10 4 123 5.5 19 4 5 12.6 ˚ 60 18 4 5 5 3-2.1 R1 C1 2-1.3 11.7 8.1 18 ø7.825 1.5 7 7.8 7.5 3 Switch ˚ 60 6.3 ø2.1 hole 7.8 7.5 3 5 12.5 7.5 11.7 8.1 ø5.975 ø1.45 1.2 R1 Switch travel 1.5 20 5 (15) 4.45 3 7 4.45 ø1.95 5 Mounting surface Switch ø5.975 5 surface 20 (15) 2-2.4 Single-shaft, single unit with push-on switch travel 1.5mm RK1191124001 Mounting ø1.95 10 4 5 5.5 60 123 4.45 ø7.825 ˚ 12.5 7.5 6.3 Knob Operating 1.2 C1 ø5.975 ø7.825 R1 ø5.975 ø1.45 R1 4.45 Switch 2-1.3 18 7 ø2.1 hole 11.7 8.1 4 5 12.6 60 7.8 7.5 3 ø1.95 ø1.45 ˚ 0.5 18 5 Switch 11.7 8.1 7.8 7.5 3 0.5 20 (15) 75 Mounting 5 surface 13 Switch travel Insulated Shaft ø1.95 5 1.2 ø1.45 A slant line part:The solder land Black part:Do not solder and wiring for electrical contact Metal Shaft 2 8.2 9 Switch travel 20 (15) 4 16.5 Shaft Shaftshown showninin full fullC.C.W C.C.Wposition position Single-shaft, single-unit with push-on switch travel 0.5mm Mounting surface RK1191114001 8.5 15 15 1 23 1.9 4.5 10 5.5 19 7.8 7.5 7.8 7.5 3 3 1.6 3-1.2 2-R0.8 3-2.1 1.2 1.2 5 Slide Potentiometers R1 R1 ø1.45 ø1.45 1 4.45 4.45 ø5.975 ø5.975 ø1.95 ø1.95 ° 6060° 12.6 77 18 18 55 2-1.3 Dummy Dummy terminal terminal 4 11.7 11.7 8.1 8.1 (15 )) (15 55 Rotary Potentiometers ø2.1 hole 20 20 Mounting Mounting surface surface Dummy Dummy terminal terminal 12.5 7.5 6.3 1.9 4.5 No. Unit:mm PC board mounting hole dimensions (Viewed from mounting side) 5 A slant line part:The solder land Black part:Do not solder and wiring for electrical contact 329 11mm Size Metal Shaft Reflow Type / Other Specifications In addition to the products listed, we can accommodate the follow specifications. Detent and Attached Switch Items Varieties Single-shaft, Single-unit Detent Attached switches travel Without 0.5mm 1.5mm Rotary Potentiometers Dimensions of Shaft Flat type Unit:mm Items Slide Potentiometers Detail dimensions(mm) R L1 ※ LB (15) 5 7 (20) 5 10 R Notes 1. ※ LB does not support M7 (with screws). 2. Marked are specifications recommended by Alps. Metal Shaft Insulated Shaft 11mm Size Metal Shaft Reflow Type / Switch Specifications Knob Operating Switch type Momentary push switch Contact arrangement Single pole and single throw(Push-on) Travel(mm) 0.5±0.3 1.5±0.5 Operating force 5±2N 4±2N Ring Type Operating life Electrical performance 330 20,000 times Rating 0.1A 5V DC (0.1mA 5V DC min. rating) Contact resistance 100mΩ max. for initial period, 200mΩ max. after operating life. Insulation resistance 100MΩ max. 250V DC Voltage proof 300V AC for 1 minute or 360V AC for 2s Refer to P.331 for ordering products not listed. 11mm Size Metal Shaft Reflow Type / Ordering Products Not Listed When ordering product varieties that are not listed, specify referring to the examples below. Sample Part Number R K 1 1 9 1 1 1 0 F 1 5 C 0 B 1 0 3 Switch Specification Switch Specification 10 Without switch 14 With momentary push switch(0.5mm travel) 24 With momentary push switch(1.5mm travel) Rotary Potentiometers Code Slide Potentiometers Length of the shaft L1(mm) Code Length of the shaft 15 15 20 20 Metal Shaft Detent Detent C0 Without Insulated Shaft Code Knob Operating 1B Output volt.across term.1-2 Input volt. across term. 1-3 90 80 Ring Type B: For tone & general 100 70 60 50 40 30 1B ) B B( Resistance taper G 100 (%) Code J Resistance taper 20 10 0 10 Term."1" 20 30 40 50 60 Rotation travel (%) 70 J 80 90 100 Term."3" Total resistance Code Total resistance(kΩ) 103 10 Note Marked are specifications recommended by Alps. 331 Metal Shaft Potentiometers List of Varieties Type 9mm size RK09L Series Number of resistor elements 11mm size RK0972 RK119 Single-shaft RK0971 Dual-shaft Single-shaft Single/dual Dual Single Photo Terminal mounting Horizontal Vertical Vertical Screw Operating temperature range Guide −20℃ to +70℃ − 40℃ to + 85℃(Vehicle-compatible) −10℃ to +70℃ 15,000 cycles — Available for automotive use — 〇 〇 〇 Life cycle (availability) Total resistance (k Ω) 10, 20, 50, 100 10 Resistance taper 15A, 1B, 3B, 15C 1B Rated Power Maximum attenuation (Volume control) R≦10kΩ 20Ω max. 10kΩ<R<50kΩ 30Ω max. 50kΩ≦R Nominal total resistance of 0.1% or less — −40dB to 0dB 3dB max. Insulation resistance — 100MΩ min. 250V DC 300V AC for 1 minute or 360V for 2s 300V AC for 1minute Center-taps Without Without / With Without Detent Without, Center Without, Center, 11, 31 Without Stopper strength 0.5N・m 0.5N・m(With push-lock mechanism: 0.4N·m) 0.5N・m Push-pull strength 80N max. 100N max. 10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the frequencies, in the 3 direction of X, Y and Z and for 2 hours respectively Vibration Shaft style Inner-shaft:flat type Outer-shaft:slotted type Flat type Terminal style Page Ring Type Voltage proof Attached switch Knob Operating Gang error applicable to Dual-unit parts for audio volume control purposes Electrical performance 5kΩ≦R< 10kΩ 70dB min. 10kΩ≦R< 50kΩ 80dB min. 50kΩ≦R<100kΩ 90dB min. 100kΩ≦R 100dB min. 5kΩ≦R< 10kΩ 70dB min. 10kΩ≦R< 50kΩ 80dB min. 50kΩ≦R 90dB min. R≦10kΩ 50Ω max. Insulated Shaft Mechanical performance Metal Shaft Residual resistance 0.05W Slide Potentiometers Operating life −40℃ to +85℃ Rotary Potentiometers Fixing method of bushing Horizontal Insertion — — 313 Flat type Reflow Rotary switch Push-on push-off switch Push-on switch — 317 Push-on switch 328 Metal Shaft Potentiometers Soldering Conditions ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 349 Potentiometers Cautions・ ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 427 Potentiometers Measurement and Test Methods・ ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 429 Potentiometers Resistance Taper・ ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 431 Notes 1. For the switch attached, the single-shaft or inner shaft of the dual-shaft type can be chosen. 2. The operating temperature range for automotive applications can be raised upon request. Please contact us for details. 3. ○ Indicates applicability to some products in the series. 311 Metal Shaft Potentiometers / Soldering Conditions Reference for Manual Soldering Series No. of solders RK09L, RK097 350℃ max. 3s max. 1 time RK203 300℃ max. 3s max. 1 time RK119 350±10℃ +1 s 3 0 1 time RK271 350℃ max. 5s max. 1 time RK501 350±10℃ +1 s 5 0 1 time RK163 350℃ max. 5s max. 1 time Potentiometer terminal 300℃ max. 3s max. 1 time Motor terminal 350℃ max. 2s max. 1 time RK168 Slide Potentiometers Soldering time Rotary Potentiometers Tip temperature Reference for Dip Soldering Preheating Soldering surface Heating time temperature Series RK501 No. of solders 100℃ max. 2 min. max. 260±5℃ 5±1s 2 time max. 120±10℃ 2 min. max. 260±5℃ 5±1s 2 time Metal Shaft RK09L, RK097, RK203 Dip soldering Soldering Soldering time temperature Insulated Shaft Example of Reflow Soldering Condition Temperature profile A B 200 C D Ring Type Temperature (˚C ) Knob Operating 300 100 Room temperature Time (s) Pre-heating E max. F max. G max. H max. Series RK119 A B C D E F G H No. of reflows 260℃ 230℃ 180℃ 150℃ 2 min. 3s 40s 4 min. 2 time max. Notes 1. When using an infrared reflow oven, solder may sometimes not be applied. Be sure to use a hot air reflow oven or at type that uses infrared rays in combination with hot air. 2. The temperatures given above are the maximum temperatures at the terminals of the potentiometer when employing a hot air reflow method. The temperature of the PC board and the surface temperature of the potentiometer may vary greatly depending on the PC board material, its size and thickness. Ensure that the surface temperature of the potentiometer does not rise to 250℃ or greater. 3. Conditions vary to some extent depending on the type of reflow bath used. Be sure to give due consideration to this prior to use. 349