HEC-100RTA-48QSCA Rev A1.0 A. Features High Efficiency (Up to 90%). Active Power Factor Correction (Typical 0.96). Isolation Class I (With FG) All-Round Protection: OVP/SCP/OTP/OPP. Fully isolated Metal case with IP67 and damp/ wet location. 1-10V, PWM, and resistance dimming function. B. Description The HEC-100RTA-48QSCA Series operate from a 90 ~ 305Vac input range. They are designed to be highly efficient and highly reliable. Features include over voltage protection, short circuit protection, and over temperature protection. C. Models Input Voltage Range Output Voltage Range Note 1 Note 4 90 ~ 305Vac 28-48V Output Current 2100mA Max. Output Power Efficiency Power Factor Note 2 Note 2 100 W 90% 0.96 Model Number HEC-100RTA-48QSCA D. Electronic Specifications - Input Specifications Parameter Min. Typ. Max. Input Voltage (V) 90 - 305 Input Frequency (Hz) 47 Notes 63 - - 1.5 Measured at full load and 100Vac input. - - 0.5 Measured at full load and 277Vac input. Leakage Current (mA) - - 0.7 At 277Vac 60Hz input. Inrush Current (A) - - 40 - 0.16 A2s At 220Vac input 25°C Cold Start. Duration=100µs, 10%Ipk-10%Ipk. 0.9 - - - 20 25 Input AC Current (A) Inrush Current (I2t) Power Factor At 277Vac input, full load. THD (%) http://www.hec-group.com.tw/ [email protected] TEL:+886-6-356-0606 FAX:+886-6-356-0505 1 HEC-100RTA-48QSCA Rev A1.0 - Output Specifications Parameter Min. Typ. Max. Notes Output Current (mA) Io = 2100 mA No Load Output Voltage (V) 1995 2205 - - Output Ripple Voltage (V) - - Output Voltage Overshoot (%) - - 110 Line Regulation (%) - - ±3 Load Regulation (%) - - ±5 Turn-on Delay Time (s) - 0.5 1.0 Min. Typ. Max. - - - - 320,000 - Io = 2100 mA 63 1% Vo max There will be no damage or hazardous conditions occurred with no loading. Measured by 20 MHz bandwidth oscilloscopes and the output paralleled a 0.1uF ceramic capacitor and a 10uF electrolytic capacitor. At full load condition. Measured at 220Vac input. - General Specifications Parameter Efficiency (%) Io = 2100 mA Efficiency (%) Io = 2100 mA MTBF (hours) Life Time (hours) Case Temperature (°C) - Dimensions Millimeters(L × W × H) 88 90 100,000 - - 85 Notes Measured at full load and 120Vac input. Measured at full load and 277Vac input. Measured at full load 50°C ambient temperature (MIL-HDBK-217F). Measured at rated input voltage with full load, Case temperature=60°C @ Tc point.See life time vs. Tc curve for the details. 70*ψ130 - Protection Functions Parameter Min. Typ. Max. 1.50 Over Voltage Protection Vomax Notes In the event of an over-voltage condition, the LED Drives shall Shut down o/p voltage, re-power on to recover. Over Temperature Protection Shut down o/p voltage with re-power on to recovery. Short Circuit Protection No damage shall occur when any output operating in a short circuit condition. The power supply shall be self-recovery when the fault condition is removed. http://www.hec-group.com.tw/ [email protected] TEL:+886-6-356-0606 FAX:+886-6-356-0505 2 HEC-100RTA-48QSCA Rev A1.0 - Environmental Specifications Parameter Min. Typ. Max. Notes Operating Temperature (°C) -40 - +70 Humidity: 20% RH to 80% RH; See Derating Curve for more details. Storage Temperature (°C) -40 - +80 Humidity: 10% RH to 90% RH. - Safety and EMC Compliance Safety Category Standard UL/CUL UL8750, UL 1012, CSA C22.2 No. 107.1 CE EN 61347-1, EN61347-2-13. EMI Standards Notes EN 55015 Conducted emission Test & Radiated emission Test. EN 61000-3-2 Harmonic current emissions. EN 61000-3-3 Voltage fluctuations & flicker. FCC Part 15 FCC 47 CFR Part 15 Subpart B, ICES-003 Issue 4 ANSI C63.4-2003 EMS Standards Notes EN 61000-4-2 Electrostatic Discharge (ESD): 8 KV air discharge, 4 KV contact discharge. EN 61000-4-3 Radio-Frequency Electromagnetic Field Susceptibility Test-RS. EN 61000-4-4 Electrical Fast Transient / Burst-EFT: Level 2, Criteria A. EN 61000-4-5 Surge Immunity Test: AC Power Line: line to line 2 KV. EN 61000-4-6 Conducted Radio Frequency Disturbances Test-CS. EN 61000-4-8 Power Frequency Magnetic Field Test. EN 61000-4-11 Voltage Dips. EN 61547 Electromagnetic Immunity Requirements Applies To Lighting Equipment. line to group 4 KV. Notes: 1. Normal input voltage range 100~277Vac. 2. Measured at input 220V with a full load. 3. All specifications are typical at 25 °C unless otherwise stated. 4. Constant current operation region is preferably 50%~100% rated output voltage. This is the suitable operation region for LED related applications, but please reconfirm special electrical requirements for some specific system design. 5. Derating may be needed under low input voltages. Please check the static curve for more details. 6. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again http://www.hec-group.com.tw/ [email protected] TEL:+886-6-356-0606 FAX:+886-6-356-0505 3 HEC-100RTA-48QSCA Rev A1.0 E. Dimming Control The dimmer control is operated from an input signal (DC voltage / PWM signal / Variable Resistor). Please refer to the diagram. Notes: 1. If the dimming pin is not used, Dimming pin can be open. Parameter Min. Typ. Max. 1-10V Dimming Voltage (V) 1 - + 10.8 PWM Signal 5 10 + 10.8 0~10K -0 - +10K ΩVariable Resistor (Ω) http://www.hec-group.com.tw/ [email protected] TEL:+886-6-356-0606 FAX:+886-6-356-0505 Notes 4 HEC-100RTA-48QSCA Rev A1.0 - DC Voltage Dimming Curve - PWM Signal Dimming Curve - Variable Resistor Curve http://www.hec-group.com.tw/ [email protected] TEL:+886-6-356-0606 FAX:+886-6-356-0505 5 HEC-100RTA-48QSCA Rev A1.0 F. Electronic Curve - Derating Curve - Static Curve - Power Factor Characteristics Curve - Efficiency Characteristics Curve http://www.hec-group.com.tw/ [email protected] TEL:+886-6-356-0606 FAX:+886-6-356-0505 6 HEC-100RTA-48QSCA Rev A1.0 - Life Time vs. Case Temperature Curve G. Mechanical Outline http://www.hec-group.com.tw/ [email protected] TEL:+886-6-356-0606 FAX:+886-6-356-0505 7 HEC-100RTA-48QSCA Rev A1.0 H. RoHS Compliance Outline Our products comply with the European Directive 2011/65/EU, calling for the elimination of lead and other hazardous substances from electronic products. I. Revision History Change Date Description of Change Rev. Item 2014-12-08 A1.0 Revised Static Curve http://www.hec-group.com.tw/ [email protected] TEL:+886-6-356-0606 FAX:+886-6-356-0505 From To / / 8