Series T • Triac output SSRs; Output rated from 10A to 25A @ 24-240 VAC • AC or DC control • Zero-crossing (resistive loads) output PRODUCT SELECTION Control Voltage 3-32 VDC 90-280 VAC 3-32 VDC 90-280 VAC 10A 25A TD1210 TA1210 TD2410 TA2410 TD1225 TA1225 TD2425 TA2425 AVAILABLE OPTIONS OUTPUT SPECIFICATIONS (1) Description Operating Voltage (47-63Hz) [Vrms] Transient Overvoltage [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mArms] Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (2) Maximum Load Current (3) [Arms] Minimum Load Current [mArms] Maximum Surge Current (16.6ms) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Thermal Resistance Junction to Case (Rjc) [°C/W] Maximum I2 t for Fusing (8.3 msec) [A2 sec] Minimum Power Factor (with Maximum Load) 10A 25A 10A 25A 24-140 400 8 200 10 40 120 1.6 1.48 60 24-140 400 8 200 25 40 250 1.6 1.02 260 24-280 600 10 200 10 40 120 1.6 1.48 60 24-280 600 10 200 25 40 250 1.6 1.02 260 0.5 0.5 0.5 0.5 INPUT SPECIFICATIONS (1) Description Control Voltage Range Minimum Turn-On Voltage Minimum Turn-Off Voltage Maximum Reverse Voltage Typical Input Current Nominal Input Impedance Maximum Turn-On Time [msec] Maximum Turn-Off Time [msec] TDxxxx TAxxxx 3-32 VDC 3.0 VDC 1.0 VDC -32 VDC 3.4 mA @ 5 VDC, 20 mA @ 28 VDC 1500 Ohm 1/2 Cycle 1/2 Cycle 90-280 VAC 90 Vrms 10 Vrms 2 mA @ 120 Vrms, 4 mA @240 Vrms 60 K Ohm 10 40 GENERAL SPECIFICATIONS Description Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 V DC) Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation Terminals Recommended Terminal Screw Torque Range: Parameters 4000 Vrms 109 Ohm 8 pF -40 to 80°C -40 to 125 °C 3.0 oz (86.5g) Thermally conductive Epoxy Screws and Saddle Clamps Furnished, Unmounted 6-32 Screws - 10 in lbs. 8-32 Screws - 20 in. lbs. (Screws dry without grase) GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 3) Heat sinking required, for derating curves see page 2 MECHANICAL SPECIFICATIONS THERMAL DERATE INFORMATION AGENCY APPROVALS UL E116949 CSA LR81689 VDE 10143 UG Rev. 090712 ANNEX - ENVIROMENTAL INFORMATION