AC Film Capacitors Motor Run Series/Type: Ordering code: UL Series B 32 329 Date: Version: 07/02 3 EPCOS AG 2015. Reproduction, publication and dissemination of this publication, enclosures hereto and the information contained therein without EPCOS' prior express consent is prohibited. EPCOS AG is a TDK Group Company. Important notes The following applies to all products named in this publication: 1. Some parts of this publication contain statements about the suitability of our products for certain areas of application. These statements are based on our knowledge of typical requirements that are often placed on our products in the areas of application concerned. We nevertheless expressly point out that such statements cannot be regarded as binding statements about the suitability of our products for a particular customer application. As a rule, EPCOS is either unfamiliar with individual customer applications or less familiar with them than the customers themselves. For these reasons, it is always ultimately incumbent on the customer to check and decide whether an EPCOS product with the properties described in the product specification is suitable for use in a particular customer application. 2. We also point out that in individual cases, a malfunction of electronic components or failure before the end of their usual service life cannot be completely ruled out in the current state of the art, even if they are operated as specified. In customer applications requiring a very high level of operational safety and especially in customer applications in which the malfunction or failure of an electronic component could endanger human life or health (e.g. in accident prevention or life-saving systems), it must therefore be ensured by means of suitable design of the customer application or other action taken by the customer (e.g. installation of protective circuitry or redundancy) that no injury or damage is sustained by third parties in the event of malfunction or failure of an electronic component. 3. The warnings, cautions and product-specific notes must be observed. 4. In order to satisfy certain technical requirements, some of the products described in this publication may contain substances subject to restrictions in certain jurisdictions (e.g. because they are classed as hazardous). Useful information on this will be found in our Material Data Sheets on the Internet (www.epcos.com/material). Should you have any more detailed questions, please contact our sales offices. 5. We constantly strive to improve our products. Consequently, the products described in this publication may change from time to time. The same is true of the corresponding product specifications. Please check therefore to what extent product descriptions and specifications contained in this publication are still applicable before or when you place an order. We also reserve the right to discontinue production and delivery of products. Consequently, we cannot guarantee that all products named in this publication will always be available. The aforementioned does not apply in the case of individual agreements deviating from the foregoing for customer-specific products. 6. Unless otherwise agreed in individual contracts, all orders are subject to the current version of the “General Terms of Delivery for Products and Services in the Electrical Industry” published by the German Electrical and Electronics Industry Association (ZVEI). 7. The trade names EPCOS, Alu-X, CeraDiode, CeraLink, CeraPad, CeraPlas, CSMP, CSSP, CTVS, DeltaCap, DigiSiMic, DSSP, ExoCore, FilterCap, FormFit, LeaXield, MiniBlue, MiniCell, MKD, MKK, MotorCap, PCC, PhaseCap, PhaseCube, PhaseMod, PhiCap, PQSine, SIFERRIT, SIFI, SIKOREL, SilverCap, SIMDAD, SiMic, SIMID, SineFormer, SIOV, SIP5D, SIP5K, TFAP, ThermoFuse, WindCap are trademarks registered or pending in Europe and in other countries. Further information will be found on the Internet at www.epcos.com/trademarks. AC Film Capacitors Motor Run B 32 329 UL Series UL 810 Construction n Dielectric: polypropylene film n Plastic case n Polyurethane resin Features n Self-healing properties n Low dissipation factor n High insulation resistance Typical applications For general sine wave applications, mainly as motor run capacitor Terminals n Flexile lead wires Mounting parts n Metal stud (max. torque = 5 Nm) Technical data and specifications Standard IEC / EN 60252 / UL810 Rated capacitance CN 2 .. 60 µF Tolerance ± 5% , ±10% Rated voltage UN 250 .. 450 Vac Rated frequency fN 50.. 60 Hz Life expectancy 10.000 h (Class B according to IEC / EN 60252) Maximum ratings Maximum permissible voltage Umax 1,1 x UN (UN: rated voltage) Maximum permissible current Imax 1,3 x IN (IN : rated current) Issue No. 3 07/02 Page 1 of 6 AC Film Capacitors Motor Run B 32 329 UL Series Technical data (cont`d) Test data AC test voltage terminal to terminal UTT 2 x UN, 60 s Insulation voltage terminals to case 2000 Vac Insulation resistance Ris or time constant t at 20 °C Rel. Humidity £ 65 °C (minimum value) 3000 s Dissipation factor tand at 20 °C £ 1,0 x 10 Maximumr rate of voltage rises du/dtmax 10 V/ms -3 (120 Hz) Climatic data Climatic category 25/085/21 in accordance with IEC 60068-1 Lower category Tmin -25 °C Upper category Tmax +85 °C Damp heat test ttest 21 days Permitted capacitance DC/C £3% Note : It should be noted that presence of harmonics produces over voltage & over current on capacitors. Resonance may cause serious damage to installation if a siginificant level of total harmonic distortion level exists for voltage or current. In such cases, series reactors must be considered. 1) Operating temperature class: In accordance with the reference standards, these temperatures are those measured on the surface on the capacitor Approved marks* EN 60252 250(2), 400 and 450V(3). UL 810 (1) (1) Currently available from Epcos do Brasil (2) Only from Epcos do Brasil, homologation in process to EPCOS India. (3) Class C (3000h) Issue No. 3 07/02 Page 2 of 6 AC Film Capacitors Motor Run B 32 329 UL Series Dimensional drawings Issue No. 3 07/02 Page 3 of 6 AC Film Capacitors Motor Run B 32 329 UL Series Ordering codes and packing units UN CN Max. dimensions Vac mF d x l (mm) 250 4 Ordering code Packing unit (pcs.) 25 x 58 B32329-C1405-+0$* 112 5 25 x 58 B32329-C1505-+0$* 112 6 25 x 58 B32329-C1605-+0$* 112 7 25 x 58 B32329-C1705-+0$* 112 8 25 x 58 B32329-C1805-+0$* 112 9 30 x 62 B32329-C1905-+0$* 112 10 30 x 62 B32329-C1103-+0$* 112 12 30 x 62 B32329-C1126-+0$* 112 15 30 x 62 B32329-C1156-+0$* 112 20 35 x 62 B32329-C1206-+0$* 84 25 35 x 71 B32329-C1256-+0$* 84 30 35 x 71 B32329-C1306-+0$* 84 35 40 x 71 B32329-C1356-+0$* 45 40 40 x 71 B32329-C1406-+0$* 45 45 40 x 71 B32329-C1456-+0$* 45 50 40 x 98 B32329-C1506-+0$* 45 55 40 x 98 B32329-C1556-+0$* 45 60 40 x 98 B32329-C1606-+0$* 45 Issue No. 3 07/02 Page 4 of 6 AC Film Capacitors Motor Run B 32 329 UL Series UN CN Max. dimensions Vac mF d x l (mm) 400 2 Ordering code Packing unit (pcs.) 25 x 58 B32329-B4205-+0$* 112 3 25 x 58 B32329-B4305-+0$* 112 4 25 x 58 B32329-B4405-+0$* 112 5 30 x 62 B32329-B4505-+0$* 112 6 30 x 62 B32329-B4605-+0$* 112 7 35 x 62 B32329-B4705-+0$* 84 8 35 x 62 B32329-B4805-+0$* 84 10 35 x 62 B32329-B4106-+0$* 84 12 35 x 71 B32329-B4126-+0$* 84 15 40 x 71 B32329-B4156-+0$* 45 20 40 x 71 B32329-B4206-+0$* 45 25 40 x 98 B32329-B4256-+0$* 45 30 40 x 98 B32329-B4306-+0$* 45 35 45 x 95 B32329-A4356-+0$* 45 40 45 x 95 B32329-A4406-+0$* 45 45 50 x 95 B32329-A4456-+0$* 32 50 50 x 95 B32329-A4506-+0$* 32 Issue No. 3 07/02 Page 5 of 6 AC Film Capacitors Motor Run B 32 329 UL Series UN CN Max. dimensions Vac mF d x l (mm) 450 3 Ordering code Packing unit (pcs.) 30 x 62 B32329-B6305-+0$* 112 6 35 x 62 B32329-B6605-+0$* 84 8 35 x 71 B32329-B6805-+0$* 84 10 40 x 71 B32329-B6106-+0$* 45 12 40 x 71 B32329-B6126-+0$* 45 15 45 x 71 B32329-A6156-+0$* 45 20 45 x 71 B32329-A6206-+0$* 45 25 45 x 95 B32329-A6256-+0$* 45 30 45 x 95 B32329-A6306-+0$* 45 35 50 x 95 B32329-A6356-+0$* 32 40 45 x 120 B32329-A6406-+0$* 45 45 50 x 120 B32329-A6456-+0$* 32 50 50 x 120 B32329-A6506-+0$* 32 Notes for ordering code: + Replace for capacitance tolerance J - ± 5% K- ± 10% $ Replace for construction 1 - Plastic case FRPP (UL94 V-2) 3 - Plastic case FRPP and M8 bolt * Replace for wire length (Dimension ‘b’ in drawing) 1: 65 mm 3: 100 mm 5: 150 mm 7: 200 mm 9: 250 mm The information contained in this data sheet describes the type of component and shall not be considered as guaranteed characteristics. Purchase orders are subject to the General Conditions for the Supply of Products and Services of the Electrical and Electronics Industry recommended by the ZVEI (German Electrical and Electronic Manufacturers' Association), unless otherwise agreed. Issue No. 3 07/02 Page 6 of 6