AZ9402 10 AMP MINIATURE POWER RELAY FEATURES • • • • • 10 Amp switching capability SPST-N.O. and SPDT configurations Epoxy sealed version available UL, CUR E44211 TUV pending GENERAL DATA CONTACTS Arrangement SPST N.O. (1 Form A) SPDT (1 Form C) Ratings Resistive load: Max. switched power: 150 W or 1250 VA N.O. Max. switched current:10 A Max. switched voltage: 30 VDC* or 277 VAC *Note: If switching voltage is greater than 30 VDC, special precautions must be taken. Please contact the factory. UL, CUR 5A at 250 VAC 10A at 125 VAC 4.2A at 277 VAC Life Expectancy Mechanical Electrical Minimum operations 1 x 107 1 x 105 at 10 A 120 VAC Res. Operate Time (max.) 8 ms at nominal coil voltage Release Time (max.) 5 ms at nominal coil voltage (with no coil suppression) Dielectric Strength 1000 Vrms contact to contact (at sea level for 1 min.) 4000 Vrms contact to coil Insulation Resistance 1 x 109 ohms minimum at 500 VDC Dropout Greater than 5% of nominal coil voltage Ambient Temperature Operating At nominal coil voltage -40°C (-40°F) to 70°C (158°F) 1/4 HP at 120/240/277 VAC Storage TV- 5 at 120 VAC -40°C (-40°F) to 105°C (221°F) Vibration 0.062" DA at 10–55 Hz Shock Mechanical 100 g for 11 ms 1/2 sine pulse Enclosure P.B.T. polyester 5A at 250 VAC Terminals Tinned copper alloy, P.C. 5A at 28 VDC Max. Solder Temp. 270°C (518°F) Max. Solder Time 5 seconds Max. Solvent Temp. 80°C (176°F) Max. Immersion Time 30 seconds Weight 7 grams Pilot Duty at 24 VA, 24 VAC ;125 VA at 120/240/277 VAC ; C150 at 120 VAC TUV Material Resistance Silver Cadmium Oxide < 0.1 Ohm (24 V, 1 A voltage drop method) COIL Power At Pickup Voltage (typical) 253 mW (Standard Coil) Max. Continuous Dissipation 1.25 W at 20°C (68°F) Temperature Rise 40°C (72°F) (Standard Coil) NOTES 1. All values at 20°C (68°F). 2. Relay may pull in with less than “Must Operate” value. Temperature Max. 105°C (221°F) 3. Specifications subject to change without notice. 7/13/2010 AZ9402 RELAY ORDERING DATA ORDER NUMBER* COIL SPECIFICATIONS – Standard Coil (SPDT and SPST) Nominal Coil VDC 3 Must Operate VDC 2.25 Max. Continuous VDC 3.3 Coil Resistance ± 10% 20 SPDT SPST-NO AZ9402–1A–3D AZ9402-1C-3D 5 3.75 5.5 56 AZ9402–1A–5D AZ9402-1C-5D 6 4.5 6.6 80 AZ9402–1A–6D AZ9402-1C-6D AZ9402-1C-9D 9 6.75 9.9 180 AZ9402–1A–9D 12 9.0 13.2 320 AZ9402–1A–12D AZ9402-1C-12D 18 13.5 19.8 720 AZ9402–1A–18D AZ9402-1C-18D 24 18.0 26.4 1280 AZ9402–1A–24D AZ9402-1C-24D *Add suffix “E” for sealed version MECHANICAL DATA PC BOARD LAYOUT .807 max. [20.50] .417 max. [10.59] .054 [1.36] .400 [10.16] .300 [7.62] .058 [1.49] .300 [7.62] * .614 max. [15.60] .016 [0.40] 5 x ø.051 [ø1.3] .100 [2.54] *omitted from Form A 5 x.150 [3.8] WIRING DIAGRAM FORM A 5 x.031 [0.8] 5 x.012±.005 [0.31±0.12] FORM C VIEWED TOWARD TERMINALS Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" 7/13/2010