PS1045L 10.0AMPS. SCHOTTKY BARRIER RECTIFIERS FEATURE MECHANICAL DATA .For surface mounted application .High current capability .Low forward voltage drop .Low power loss, high efficiency .High surge current capability .High temperature soldering guaranteed: 260°C /10 seconds at terminals. .Terminal: Solder plated .Case: Molded with UL-94 Class V-0 recognized Flame Retardant Epoxy PS-277B D b2 D2 A A2 L W1 E1 E W E2 L1 e b1 b1 A2 LEFT PIN RIGHT PIN BOTTOM SIDE HEAT SINK NO Dimensions NO Dimensions A 1.20±0.1 e 1.84Typ A2 0.25±0.05 E1 5.3±0.1 b1 0.9±0.1 E2 3.3±0.2 b2 1.8±0.1 L 0.6±0.1 D 3.95±0.1 L1 0.6±0.1 D2 3.00Typ W 1.3±0.2 E 6.5±0.1 W1 0.8±0.15 All Dimensions in mm MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25°C ambient temperature unless otherwise specified. Single phase, half wave, 60Hz,resistive or inductive load. For capacitive load, derate current by 20% SYMBOL PS1045L Type Number units Maximum Recurrent Peak Reverse Voltage VRRM 45 V Maximum RMS Voltage VRMS 31.5 V Maximum DC blocking Voltage VDC 45 V Average Forward Rectified Output Current IF(AV) 10.0 A IFSM 200.0 A Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC method) Maximum Instantaneous Forward @TA=25°C Voltage at 2.0A DC @ TA =100°C Maximum Instantaneous Forward @TA=25°C Voltage at 10.0A DC @ TA =100°C Maximum DC Reverse Current @TA=25°C atratedDCblockingvoltage @TA=100°C Typical Junction Capacitance (Note1) 0.33 VF 0.27 0.45 V 0.42 IR 0.2 10.0 mA CJ 600 pF Typical Thermal Resistance (Note2) R(JA) 31 °C/W Storage Temperature TSTG -55 to +150 °C TJ -55 to +150 °C Operating Junction Temperature Note: 1. Measured at 1.0 MHz and applied reverse voltage of 4.0Vdc 2. Polymide PCB, 2oz. Copper. Cathode pad dimensions 18.8mm x 14.4mm. Anode pad dimensions 5.6mm x 14.4mm.