SDER041H

Page 1 of 3
Delta Part No﹒︰SDER041H type
Part Name︰Sealed Choke
Sealed Choke Coil SDER041H type

Features
Low profile:4.0mm x 4.0mm x 1.8mm
Low coil resistance with large currents.
High magnetic shield construction should actualize high resolution for EMC protection.
100% lead (Pb) free meet RoHS standard

Application
Cellular phones, LCD displays, HDDs, DVCs, DSCs, PDAs etc..

Outline Dimensions
W
L
Code
Dimensions (mm)
L
4.0  0.2
W
4.0  0.2
T
1.8 Max
* Dimensions are of the case not including the
T
termination. For maximum overall dimensions
including the termination, add 0.1mm.
Note:This graph is in regard to outline dimensions spec. For outer appearance, please refer to actual product.
Page 2 of 3

Marking
The inductor is marked with a 3-digit code
Example – – 10H  100
100

Recommend Land Pattern Dimensions
The customer shall determine the land dimensions shown below after confirming and safety.
B
A
C
A
3.6
B
1.8
C
4.1
Unit : mm
Page 3 of 3

Specifications
Part Number
SDER041H-2R2MS
SDER041H-3R3MS
SDER041H-4R7MS
SDER041H-6R8MS
SDER041H-8R2MS
SDER041H-100MS
SDER041H-150MS
SDER041H-220MS
SDER041H-330MS
SDER041H-470MS
L0
Inductance
( H )
@ (0A)
Heat Rating Current
DC Amps. Idc ( A )
Rdc ( m)
Typical
2.2
3.3
4.7
6.8
8.2
10.0
15.0
22.0
33.0
47.0
35
45
69
90
105
134
185
250
405
495
Saturation Current
DC Amps. Isat ( A )
Maximum
Typical
Maximum
Typical
Maximum
45
56
89
115
132
169
222
315
486
594
3.10
2.75
2.30
2.10
1.50
1.50
1.45
1.20
0.90
0.80
2.80
2.50
2.07
1.90
1.35
1.35
1.30
1.08
0.81
0.72
3.10
2.45
2.05
1.75
1.60
1.55
1.10
0.95
0.70
0.58
2.80
2.20
1.85
1.60
1.44
1.40
1.00
0.85
0.63
0.52
* :If you require another part number please contact with us.
**:Inductance Tolerance  20%
Note 1.: All test data is referenced to 25℃ ambient.
Note 2.: Test Condition:100KHz, 1.0Vrms
Note 3.: Idc : DC current (A) that will cause an approximate △T of 40℃
Note 4.: Isat : DC current (A) that will cause L0 to drop approximately 30%
Note 5.: Operating Temperature Range -55℃ to + 125℃
Note 6.: The part temperature (ambient + temp rise) should not exceed 125℃ under the worst case operating
conditions. Circuit design, component placement, PCB trace size and thickness, airflow and other cooling
provision all affect the part temperature. Part temperature should be verified in the end application.
Note 7.: The rated current as listed is either the saturation current or the heating current depending on which value is
lower.