FR101G thru FR107G Glass Passivated Fast Recovery Rectifiers Reverse Voltage 50 to 1000 Volts Forward Current 1.0 Ampere Features Low forward voltage drop High current capability High reliability High surge current capability Mechanical Data Case: Molded plastic DO-204AL (DO-41)/A-405 Epoxy: UL 94V-O rate flame retardant Lead: Axial leads, solderable per MIL-STD-202, Method 208 guaranteed Polarity: Color band denotes cathode end High temperature soldering guaranteed: 250oC/10 seconds .375” (9.5mm) lead lengths at 5 lbs., (2.3kg) tension Weight: DO-41 - 0.012 ounce, 0.335 gram A-405 - 0.008 ounce, 0.235 gram Note: Lead diameter is 0.025(0.64)/0.021(0.53) for part numbers from FR101SG thru FR107SG Maximum Ratings and Electrical Characteristics Ratings at 25oC ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20% Parameter Symbols FR101G FR102G FR103G FR104G Maximum repetitive peak reverse voltage VRRM 50 100 200 Maximum RMS voltage VRMS 35 70 140 Maximum DC blocking voltage V DC 50 100 200 Maximum average forward rectified current 0.375" (9.5mm) lead length at TA=55oC I(AV) 1.0 Amp Peak forward surge current, 8.3 ms single half sine-wave superimposed on rated load (JEDEC Method) IFSM 30.0 Amps VF 1.3 Volts IR 5.0 100 uA Maximum instantaneous forward voltage @ 1.0A Maximum DC reverse current at rated DC blocking voltage o @TA=25 C @TA=125oC FR105G FR106G FR107G Units 400 600 800 1000 Volts 280 420 560 700 Volts 400 600 800 1000 Volts Maximum reverse recovery time (Note 1) trr Typical junction capacitance (Note 2) CJ 12 Operating junction temperature range TJ -55 to +150 o C -55 to +150 o C Storage temperature range Notes: 150 TSTG 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A 2. Measured at 1 MHz and Applied Reverse Voltage of 4.0 V D.C. 79 250 500 nS pF RATINGS AND CHARACTERISTIC CURVES 80