Model MM4xSMx-10 Model MM4xSMx-14 Double Balanced Mixer Multi-Octave Band RF 2.0 to 8.0 GHz Electrical Specifications: (1) Specifications Conditions RF (GHz) 2.0-8.0 2.0-8.0 2.0-8.0 Parameter SSB Conversion loss: (2) (3) Isolation LO to RF: LO to IF: RF to IF: Input 1 dB Compression Point: 2.0-8.0 2.0-8.0 LO (GHz) 2.0-8.0 2.0-8.0 2.0-8.0 IF (MHz) DC-500 DC-1000 DC-1500 2.0-8.0 2.0-8.0 2.0-8.0 DC-1500 Input Third Order Intercept Point: 2.0-8.0 2.0-8.0 DC-1500 LO Power: (4) 2.0-8.0 2.0-8.0 DC-1500 Min Typical 5.0 dB 6.0 dB 7.0 dB 33 dB 37 dB 22 dB +1 dBm +4 dBm +8 dBm +12 dBm +11 dBm +14 dBm +18 dBm +22 dBm +7 dBm +10 dBm +13 dBm +18 dBm Max 7.0 dB 8.0 dB 9.5 dB Model MM4xSMx-10 Model MM4xSMx-14 MM43 MM44 MM46 MM47 MM43 MM44 MM46 MM47 MM43 MM44 MM46 MM47 LO Power 3 = +7 dBm 4 = +10 dBm 6 = +13 dBm 7 = +18 dBm D = No Cover H = With Cover Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25˚C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within ±0.5 dB of conversion loss for IF frequencies greater than 10 MHz. 3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -55˚C. 4. Usable LO drives are up to 2 dB below and 3 dB above nominal. 5. See Application Note M112, for aid in selecting the outline and for mounting and installation information. MM4xSMD-10 MM4xSMx-10: AS SHOWN MM4xSMx-14: RF & LO REVERSED MM4xSMH-10 Outline: SMMD2A: AS SHOWN SMMD2B: RF & LO REVERSED Typical Performance at 25˚C Outline: SMMH2A: AS SHOWN SMMH2B: RF & LO REVERSED All dimensions are in inches and [mm]. Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, FL 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave (Europe) · 2707 Black Lake Place · Philadelphia, PA 19154 · PH (215) 464-4000 · Fax (215) 464-4001