Package Information www.vishay.com Vishay Siliconix SC-75A: 3 Leads L2 A 2 D 1 D bbb D e2 2X D 3 L1 L B1(b1) 3 e1 3 E/2 1 2 E E1 1 1 bbb D 1 2 C bbb C D 4 ddd M C B 3 2X e3 B1 b1 2XB1 A– B B B 2X D c1 C With Tin Planting bbb D Section B-B 5 A A2 Base Metal C 4X Seating Plane A1 D DWG: 5868 Notes Dimensions in millimeters will govern. 1.Dimension D does not include mold flash, protrusions or gate burrs. Mold flash protrusions or gate burrs shall not exceed 0.10 mm per end. Dimension E1 does not include Interlead flash or protrusion. Interlead flash or protrusion shall not exceed 0.10 mm per side. 2.Dimensions D and E1 are determined at the outmost extremes of the plastic body exclusive of mold flash, tie bar burrs, gate burrs and interlead flash, but including any mismatch between the top and bottom of the plastic body. 3.Datums A, B and D to be determined 0.10 mm from the lead tip. 4.Terminal positions are shown for reference only. 5.These dimensions apply to the flat section of the lead between 0.08 mm and 0.15 mm from the lead tip. DIMENSIONS TOLERANCES aaa 0.10 bbb 0.10 ccc 0.10 ddd C15-1445-Rev. F, 23-Nov-15 0.10 DIM. MILLIMETERS MIN. NOM. MAX. A - - 0.80 A1 0.00 - 0.10 NOTE A2 0.65 0.70 0.80 B1 0.19 - 0.24 b1 0.17 - 0.21 c 0.13 - 0.15 c1 0.10 - 0.12 5 D 1.48 1.575 1.68 1, 2 E 1.50 1.60 1.70 E1 0.66 0.76 0.86 e1 0.50 BSC e2 1.00 BSC e3 L 5 5 1, 2 0.50 BSC 0.15 0.205 L1 0.40 ref. L2 0.15 BSC 0.30 q 0° - 8° q1 4° - 10° Document Number: 71348 1 For technical questions, contact: [email protected] THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000