SF11 thru SF19 Glass Passivated Super Fast Rectifiers Reverse Voltage 50 to 1000 Volts Forward Current 1.0 Ampere Features Low forward voltage drop High current capability High reliability High surge current capability Mechanical Data Case: Molded plastic DO-204AL(DO-41)/A-405 Epoxy: UL 94V-O rate flame retardant Lead: Axial leads, solderable per MIL-STD-202, Method 208 guaranteed Polarity: Color band denotes cathode end High temperature soldering guaranteed: 250oC/10 seconds .375” (9.5mm) lead lengths at 5 lbs., (2.3kg) tension Mounting position: Any Weight: DO-41 - 0.012 ounce, 0.335 gram A-405 - 0.008 ounce, 0.22 gram Note: Lead diameter is 0.025(0.64)/0.021(0.53) for suffix "S" part numbers Maximum Ratings and Electrical Characteristics Ratings at 25oC ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20% Parameter Symbols SF11 S F 12 S F 13 S F 14 S F 15 S F 16 S F 17 S F 18 S F 19 Units Maximum repetitive peak reverse voltage VRRM 50 100 150 200 300 400 600 800 1000 Volts Maximum RMS voltage VRMS 35 70 105 140 210 280 420 560 700 Volts Maximum DC blocking voltage V DC 50 100 150 200 300 400 600 800 1000 Volts Maximum average forward rectified current .375" (9.5mm) lead length @TA=55oC I(AV) 1.0 Amp Peak forward surge current, 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) IFSM 30.0 Amps Maximum instantaneous forward voltage @ 1.0A VF Maximum DC reverse current at rated DC blocking voltage @ TA=25oC @ TA=125oC Maximum reverse recovery time (Note 1) Typical junction capacitance (Note 2) Typical thermal resistance Operating junction temperature range Storage temperature range Notes: 0.95 1.3 1.7 Volts IR 5.0 100 uA uA trr 35 nS CJ 40 25 pF RθJA RθJL 60 20 TJ -55 to +150 o C -55 to +150 o C TSTG 1. Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A 2. Measured at 1 MHz and Applied Reverse Voltage of 4.0 V D.C. 225 o C/W RATINGS AND CHARACTERISTIC CURVES 226