UNISONIC TECHNOLOGIES CO., LTD UCR2PM Preliminary TRIACS 2A TRIAC DESCRIPTION The UTC UCR2PM is a 2A standard triac, The UTC UCR2PM is suitable for use in electric pot, electric rice cooker and controller for other heater. FEATURES * IT(RMS): 2A * VDRM: 800V (TJ=125°C) * IGT I-II-III: 10mA SYMBOL MT2 G MT1 ORDERING INFORMATION Ordering Number Lead Free Halogen Free UCR2PML-x-TF3-T UCR2PMG-x-TF3-T Note: Pin Assignment: MT1: MT1 MT2: MT2 G: Gate UCR2PML-x-TA3-T Package TO-220F Pin Assignment 1 2 3 MT1 MT2 G (1)Packing Type (1) T: Tube (2)Package Type (2) TA3: TO-220 (3)Lead Free (3) 8: 800V (4)Lead Free (4) L: Lead Free, G: Halogen Free Packing Tube MARKING www.unisonic.com.tw Copyright © 2014 Unisonic Technologies Co., Ltd 1 of 3 QW-R220-020.a UCR2PM Preliminary TRIACS ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL TJ=125°C TJ=150°C Repetitive Peak Off-State Voltage (Note 1) VDRM RATINGS 800 700 840 UNIT V V V MAX 45 UNIT °C/W Non-Repetitive Peak Off-State Voltage (Note 1) VDSM On-State RMS Current IT(RMS) 2 A (Commercial Frequency, Sine Full Wave 360° Conduction) Surge On-State Current ITSM 10 A (60Hz Sinewave 1 Full Cycle, Peak Value, Non-Repetitive) I2t for Fusing (Value Corresponding to 1 Cycle of Half I2 t 0.41 A2 s Wave 60Hz, Surge On-State Current) Peak Gate Current IGM 1 A Peak Gate Power Dissipation PGM 1 W Average Gate Power Dissipation PG(AV) 0.1 W Peak Gate Voltage VGM 6 V Storage Junction Temperature TSTG -40~+150 °C Operating Junction Temperature TJ -40~+150 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. THERMAL RESISTANCES PARAMETER SYMBOL θJA Junction to Ambient ELECTRICAL CHARACTERISTICS (TJ=25 °C, unless otherwise specified) PARAMETER SYMBOL Gate Trigger Current (Note 2) IGT Gate Trigger Voltage (Note 2) VGT Gate Non-Trigger Voltage Holding Current (Note 2) VGD IH Latching Current Critical Rate of Rise of Off-State commutation Voltage (Note 3) IL (dv/dt)c TEST CONDITIONS I TJ=25°C, VD=6V, II RL=6Ω, RG=330Ω III I TJ=25°C, VD=6V, II RL=6Ω, RG=330Ω III TJ=150°C, VD=1/2 VDRM IT=300mA I-II IG=1.2IGT II MIN TJ=125°C 0.5 TYP 0.1 2.98 5 10 MAX UNIT 10 mA 10 mA 10 mA 2.0 V 2.0 V 2.0 V V mA mA mA V/µs STATIC CHARACTERISTICS PARAMETER On-State Voltage SYMBOL VTM TEST CONDITIONS TJ=25°C, ITM=3A, Instantaneous Measurement TJ=150°C, VDRM Applied MIN TYP MAX UNIT 2.1 V Repetitive Peak Off-State Current IDRM 1.0 mA Notes: 1. Gate open. 2. Measurement using the gate trigger characteristics measurement circuit. 3. Test conditions of the critical-rate of rise of off-state commutation voltage is shown in the table below. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 3 QW-R220-020.a UCR2PM Preliminary TRIACS COMMUTATING VOLTAGE AND CURRENT WAVEFORMS (INDUCTIVE LOAD) Note: Test Conditions: 1. Junction temperature: TJ=125°C 2. Rate of decay of on-state commutating current: (di/dt)c=-1.0A/ms 3. Peak off-state voltage: VD=400V TEST CIRCUITS 6Ω A 6V V RG Test Procedure III UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 3 QW-R220-020.a