NSVS1187 Apr. 2013 NewJRC SAW FILTER NSVS1187 Application 448.0MHz R.K.E Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig.1. Table 1. Electrical Specifications Item Spec. Typ. Input and Output Impedance 50Ω Nominal Center Frequency (f0) 448.0MHz Insertion Loss 3.0dB max. 2.2dB 446.0M～450.0MHz Response Variation 1.5dB max. 0.6dB Out of Band Rejection 403.2M～407.2MHz 50dB min. 60dB (Relative to Through Level) 488.8M～492.8MHz 45dB min. 54dB (Operating Temperature Range: -40~+85ºC) (Temperature characteristic is excluded):Typ. Maximum Rating: (Table 2) Table 2. Maximum Ratings Item Maximum Input Power Maximum DC Voltage Operating Temperature Range Storage Temperature Rating +10dBm 7.5V -40~+85ºC -40~+85ºC Mechanical Specifications: (Fig.2) Package is designed as small as 3.0x3.0x1.15[mm3] for SMD (Surface Mount Device) type. Notice: This part is electrostatic discharge sensitive and may be damaged by improper handling. http://www.njr.co.jp/products/device/index.html http://www.njr.com/products/device/index.html (Japanese) (English) NSVS1187 Apr. 2013 IN 50Ω 1 OUT 50Ω 6 2 SAW 5 3 4 Fig.1 Measuring circuit (a) 3. 0±0. 15 ( b) 3. 0 ± 0. 1 5 951 ( c) BM (1) ( 0. 6) ( 0. 2 5) 1. 1 5 ± 0. 1 5 ( 2) 4 ( 0. 6) [ 2 x] 3 2 5 Marking (1) Lot Number (a) Year (b) Month *Oct.--Nov.--Dec.--(c) Date 1-9--10-19--20-31--(2) Part Number Mark ( 1. 80) 1 ( 0. 75) ( 0. 45) [ 4x] ( 0. 5 3) [ 4 x] 6 Fig.2 Package dimensions (in mm) 0.93 3.8 1.15 3.8 0.6 2.2 0.93 1.15 Fig.3 Desirable land area (in mm) Pin no. 1 2 3 4 5 6 Connection GND IN/OUT GND GND OUT/IN GND X Y Z 0 1 2 NSVS1187 Apr. 2013 Notice 1. Use this component within operating temperature range. It might not be satisfied with electrical specification without operating temperature range. When it is used less than -40ºC or more than +85ºC, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. 2. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350ºC max., the time of soldering: 10 seconds max., the power of soldering iron: 30W max.. 3. Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. 4. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. 5. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. 6. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. And do not transport this component with bare hand. 7. As it might be a cause of degradation or destruction to apply D.C. voltage between each terminal, apply D.C. voltage 7.5V max. in actual circuit. Note 1. This specification specifies the quality of this component as a single unit. Make sure that this component is evaluated and confirmed against this specification when it is mounted to your products. 2. The information contained herein may be changed without prior notice. It is therefore advisable to contact New Japan Radio Company before proceeding with the design of equipment incorporating this product. 3. The products are designed to be used with ordinary electronic equipment (data and communications equipment, office equipment, audio-video equipment, measuring instruments, etc). New Japan Radio Company does not assume any liability for the case using the products with the application required high reliability or safety extremely (such as space equipment, sea-bottom equipment, medical equipment etc). When intending to use any our product please contact our sales representatives in advance. 0 Smith Chart Insertion Loss S11 20 40 60 80 [dB] 100 398 448 Frequency[MHz] Return Loss 498 S22 [5dB/div] Center Freq. 448 [MHz] Freq.Span 100 [MHz] Insertion Loss 0 Reference 0 [dB] 2 Division 1 [dB] 4 6 8 [dB] 10 423 448 473 Frequency[MHz] VSWR 11 10 9 8 7 6 5 4 3 2 1 423 448 473 Frequency[MHz]