Document 1259 Coupled Inductor – NA5880-AE • Developed for use with Fairchild Semiconductor FAN8831 Sinusoidal Piezoelectric Actuator Driver • 1 : 4 turns ratio; Output voltages up to 300 V Core material Ferrite Environmental RoHS compliant, halogen free Terminations RoHS compliant matte tin over silver-palladiumplatinum-glass frit. Weight 64 mg Ambient temperature –40°C to +85°C Maximum part temperature +165°C (ambient + temp rise). Storage temperature Component: –40°C to +125°C. Tape and reel packaging: –40°C to +80°C Winding to winding isolation (Hipot) 300 V Resistance to soldering heat Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles Moisture Sensitivity Level (MSL) 1 (unlimited floor life at <30°C / 85% relative humidity) Failures in Time (FIT) / Mean Time Between Failures (MTBF) 38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332 Packaging 1000/7″ reel; 3500/13″ reel Plastic tape: 12 mm wide, 0.25 mm thick, 8 mm pocket spacing, 1.32 mm pocket depth Recommended pick and place nozzle OD: 4 mm; ID: ≤ 2 mm PCB washing Tested to MIL-STD-202 Method 215 plus an additional aqueous wash. See Doc787_PCB_Washing.pdf. DCR maxSRF typ3 Part Inductance2Turns (Ohms) Isat4 number1 ±20% (µH) ratio L1 L2 (MHz) (A) NA5880-AE_3.3 1 : 4 0.3062.30 12 Dot indicates pin 1 1 4 1.3 1. When ordering, please specify packaging code: NA5880-AEC Packaging: C = 7″ machine-ready reel. EIA-481 embossed plastic tape (1000 parts per full reel). B=Less than full reel. In tape, but not machine ready. To have a leader and trailer added ($25 charge), use code letter D instead. D = 13″ machine-ready reel. EIA-481 embossed plastic tape. Factory order only, not stocked (3500 parts per full reel). 2. Inductance is for the primary (L1), measured at 100 kHz, 0.1 Vrms, 0 Adc on an Agilent/HP 4284A LCR meter or equivalent. 3. SRF measured using an Agilent/HP 4191A or equivalent. 4. DC current applied to L1, at which the inductance drops 10% from its value without current. 5. Electrical specifications at 25°C. Refer to Doc 362 “Soldering Surface Mount Components” before soldering. 2 1 0.155 ±0.003 3,94 ±0,08 332X 4 L1 L2 3 2 3 Inductance Internal code Value 0.0433 ±0.004 1,10 ±0,10 Recommended Land Pattern 0.155 ±0.003 3,94 ±0,08 1 4 0.031 0,78 0.103 0.049 2,61 1,25 Dimensions are in inches mm 0.174 4,40 3 2 0.060 1,52 45° typ 0.049 1,25 0.103 2,61 0.174 4,40 Document 1259 Revised 05/04/15