A 0.23 5.8 B C 0.23 5.8 A Ø 0.10"(2.5 mm) CENTER PIN REF 0.16 4.0 B Ø 0.08"(2.0mm) CENTER PIN REF L712RA L722RA CENTER PIN SLEEVE SHUNT SLEEVE L732RA POWER JACK 5/16-32 UNEF 2A THREAD REF 0.92 23.3 0.43 11.0 SCHEMATIC C Ø 0.05"(1.3mm) SOLID CENTER PIN REF 0.315 8.0 CENTER PIN 0.550 13.96 0.285 7.2 BUSHING FLAT 0.220±0.002 5.6±0.05 0.330 8.4 CENTER PIN SLEEVE 0.130±0.002 3.3±0.05 (SEE NOTE 1) FLAT WASHER CENTER PIN MOUNTING SURFACE OF BUSHING 0.067±0.001 1.7±0.03 TYP SHUNT SLEEVE 0.550 13.96 SLEEVE 0.130±0.002 3.3±0.05 (SEE NOTE 1) 5/16-32 UNEF HEX NUT 0.330 8.4 SLEEVE SHUNT RECOMMENDED PCB LAYOUT (COMPONENT SIDE) NOTES: CUSTOMER DRAWING 1. FOR HAND INSERTION USE SPACING 0.130 [3.30] FOR AUTOMATED INSERTION USE SPACING 0.135 [3.43] THIS DRAWING DESCRIBES A DESIGN CONSIDERED PROPRIETARY IN NATURE, DEVELOPED AND MANUFACTURED BY SWITCHCRAFT INC. AND IS RELEASED ON A CONFIDENTIAL BASIS FOR IDENTIFICATION PURPOSES ONLY. 2. DIMENSIONS SHOWN FOR REFERENCE ONLY. UNLESS OTHERWISE SPECIFIED 3. HEX NUT AND FLAT WASHER SUPPLIED UNASSEMBLED. 4. MATERIAL: HOUSING, HEX NUT - COPPER ALLOY, NICKEL PLATED INSULATOR HOUSING - THERMOPLASTIC TERMINAL INSULATORS - PHENOLIC FLAT WASHER - STEEL, NICKEL PLATED PIN, SPRING, TERMINALS - COPPER ALLOY, SILVER PLATED 5. THESE PRODUCTS ARE RoHS COMPLIANT 1. ALL DIMENSIONS IN INCHES SIZE FINISH - TWO PLACE DECIMALS 0.02 - THREE PLACE DECIMALS 0.005 SPEC No. FIRST USED ON DATE DRAWN D REV 26591 ECO NUMBER 8-6-10 DATE REVISIONS RS BY 3-4-99 TJK APVD WIDTH * DO NOT SCALE DRAWING SolidWorks CAD File NAME * * * MM LBS/M * TEMPER * * * MATERIAL SPEC No. * SCALE 2:1 * BY MULT CHKD MM 3-4-99 APVD JF 3-4-99 SHEET PART No. 1 OF 1 POWER JACKS L712RA, L722RA, L732RA, RoHS L712RA L722RA L732RA B REV D