UNISONIC TECHNOLOGIES CO., LTD DTB114E PNP SILICON TRANSISTOR DIGITAL TRANSISTORS (BUILT-IN BIAS RESISTORS) FEATURES * Built-in bias resistors that implies easy ON/OFF applications. * The bias resistors are thin-film resistors with complete isolation to allow positive input. EQUIVALENT CIRCUIT ORDERING INFORMATION Ordering Number DTB114EG-AE3-R DTB114EG-AL3-R Note: Pin Assignment: G: GND I: IN Package SOT-23 SOT-323 Pin Assignment 1 2 3 G I O G I O Packing Tape Reel Tape Reel O: OUT MARKING www.unisonic.com.tw Copyright © 2014 Unisonic Technologies Co., Ltd 1 of 3 QW-R206-042.E DTB114E PNP SILICON TRANSISTOR ABSOLUTE MAXIMUM RATINGS (TA = 25°C, unless otherwise specified) PARAMETER SYMBOL RATING UNIT Supply Voltage VCC -50 V Input Voltage VIN -40~+10 V IOUT Output Current -500 mA PD Power Dissipation 200 mW Junction Temperature TJ 150 °C Storage Temperature TSTG -55 ~ +150 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL CHARACTERISTICS (TA = 25°C, unless otherwise specified.) PARAMETER SYMBOL VIN(OFF) Input Voltage VIN(ON) Output Voltage VOUT(ON) Input Current IIN Output Current IOUT(OFF) DC Current Gain hFE Input Resistance R1 Resistance Ratio R2/R1 Transition Frequency fT Note: Transition frequency of the device TEST CONDITIONS VCC= -5V, IOUT= -100μA VOUT= -0.3V, IOUT= -10mA IOUT/IIN= -50mA/-2.5 mA VIN= -5V VCC= -50V , VIN=0V VOUT= -5V, IOUT= -50mA VCE= -10 V, IE=5mA, f=100MHz(Note) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN TYP MAX -0.5 UNIT -0.1 -0.3 -0.88 -0.5 V mA μA 10 1 200 13 1.2 kΩ -3 56 7 0.8 V MHz 2 of 3 QW-R206-042.E DTB114E ■ PNP SILICON TRANSISTOR TYPICAL CHARACTERISTICS UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 3 QW-R206-042.E