RGB Programs Sequences scene 1 scene 2 scene 3 scene 4 scene 5 scene 6 standard scene 7 scene 8 scene 9 control voltage Ω- value n/a n/a n/a > 8V > 80 kΩ n/a <2V < 20 kΩ n/a n/a 2-3 V n/a n/a 3-4 V 20-30 kΩ 30-40 kΩ 40-50 kΩ 50-60 kΩ 60-70 kΩ 70-80 kΩ warm cold n/a intense 4-5 V pastel n/a summer sunset Tai Chi n/a n/a n/a 5-6 V n/a n/a n/a 6-7 V n/a 7-8 V The „Standard“ – sequence is the original sequence of the OT RGB Sequencer before Sept. 06 Geometry Wiring diagram Note The controlling of the 1...10V-interfaces can e.g. be realised by a potentiometer, DALI to 1…10V-converters or by the respective interface. The 1-10V interfaces have a common cathode. On the secondary side there are 3 connection terminals available for the anode. They are internally connected, they are only used to offer more installation comfort. The control signals have to be SELV-signals. Please regard the installation requirements for SELV-signals. The OT RGB Sequencer is an accessory for electronic converters. Different OT RGB Sequencer in one application can cause problems, because there is no synchronisation between the control units. Instruction sheet Please consult the instruction sheet for further important information on dimming characteristic, wire stripping and wiring limitations in system installations. The instruction sheet is available upon request.