DC Sensor Blower Only available for OEM S 2000 Type 02X Small sensor blower for active ventilation of temperature sensors used for climate control in cars.The active ventilation of the integrated sensor avoids mismeasurements due to irradiation of various heat sources. Significant reduced overall size due to the new motor technique of an external rotor motor on pinch pole basis. - Version with temperature sensor - Modular design with possible mechanical fixing also electrical connection from flange and back side - Plug-in version (without drive electronics) - Sintec slide bearing system rpm l/min °C °C h dB (A) g 934 1706 02X 8...16 13 <50 2 700 18 -40...+95 -40...+100 5 000 <26 14 * Measured at free air delivery. Microphone distance 10 cm. Sensor blower assembled freerunning in elastic bands. 5 (in H ² O) Pa All data are based on the operation with the commutation electronics indicated on the reverse side (average values at nominal voltage). 2 0,012 Dpf S 1 0,008 3 0,004 4 0,016 13 V DC 0,1 · VS 0,3 5 0,5 10 15 CFM m³/h ebm-papst St. Georgen GmbH & Co. KG Hermann-Papst-Straße 1 • D-78112 ST. GEORGEN • Phone +49 (0) 77 24 / 81-0 • Fax +49 (0) 77 24 / 81-1309 • [email protected] • www.ebmpapst.com Mass Storage Temp. mA (free air) Operating Temp. V DC Noise* Air flow V DC enviroment temp.) Rated Speed (free air) Service life (at 23 °C Rated Voltage Type Nominal data (free air) Voltage Range Current Consumption - Quality Management ISO/TS 16949 Wiring diagram NTC-resistor 10 kW ± 3,5% at 25° For the wiring diagram we recommend a driveelectronics with protection against high voltage and reversed polarity. 6 External Drive-Electronics VCC 8 V - 16 V 5 Main winding Ri approx. 127 W Coil 2 33 k 10 k Blower diagnosis posible with specially equipped drive electronics (wiring diagram on request). 3 220 nF/25 V/X7R 4 Speed winding Ri approx. 257 W Coil 1 360 R/0.1 W BC 817 - 40 2x BC 847 C oder 1x FMW 3 GND BAS 221 2 Sensor blower 2x BZX 284 C5V1 100° Dimensions 3,6 45° Ø 27,6 Ø 18 +0,1 All dimensions in mm. Engineering drawing with tolerance indication on request. 6 5 4 3 2 1 21 ±0,1 3,3 ±0,2 18 ±0,1 With this S 2000 plug-in variant you are able to integrate the drive-electronics and the temperature sensor on your own choise. You can also place it on your PCB. 1 3 -0,4 6 10,6 0,6 +0,1 20,5 ±0,4 Fixing Mounting by clip fixing on the PCB. Electrical terminals via soldering pins (terminals are not suitable for plug-type connection). Gold-plated pins for a direct plug-type connection on request. L1053 EN Subject to technical changes 0307