MATERIAL DECLARATION SHEET Material PM127S Product Line SMD POWER INDUCTOR Date 05-December-2006 No. Construction element 1 Core 2 3 4 5 Solder Base Wire Adhesive Headquarters Riverside CA Material group Ferrite Ni-Zn Series Bar Solder Material Weight [g] if applicable Average mass [%] Sum [%] NiO 13463-39-3 13 100 ZnO 1314-13-2 30 CuO 7647-01-0 7 Fe2O3 1309-37-1 50 Sn 7440-31-5 99.3 Cu 7440-50-8 0.7 LCP N/A N/A Cu/Ni/Sn100% N/A N/A Cu 7440-50-8 90.08~99.00 Polyester Resin N/A 1~9.92 Epoxy Resin 25068-38-6 N/A Materials 2.25 0.13 Base & Terminal Electrode 0.2 Enameled Copper Wire 1.05 Epoxy 0.5 Total weight 4.13 www.bourns.com CAS Traces 100 100 100 100 page 1 of 2 MATERIAL DECLARATION SHEET Contact person Cathy Godfrey Bourns location Riverside, CA Phone Ext. 5008 Bourns , Inc. 1200 Columbia Ave. Riverside, CA 92507 USA phone: 909 781-5690 fax: 909 781-5273 Fax e-mail [email protected] Important remarks: 1. 2. 3. 4. Traces are product parts substances etc. that are below a percentage of 0.1% of total weight. A list of the legally regulated substances or materials is available at internet address http://www.eicta.org/content.asp?pageID=113 Substances, materials etc. with possible harm to men and environment are listed. There are no risks for human beings and to the environment if products are used properly as designated. This shall not apply to risks caused during procedures for disposal etc. 5. All statements herein are based on our present knowledge. Headquarters Riverside CA www.bourns.com page 2 of 2