TIP42, TIP42A, TIP42B, TIP42C

TIP42, TIP42A, TIP42B, TIP42C
PNP SILICON POWER TRANSISTORS
Designed for Complementary Use with the
TIP41 Series
TO-220 PACKAGE
(TOP VIEW)
65 W at 25°C Case Temperature
6 A Continuous Collector Current
10 A Peak Collector Current
B
1
C
2
Customer-Specified Selections Available
E
3
This series is obsolete and
not recommended for new designs.
Pin 2 is in electrical contact with the mounting base.
MDTRACA
absolute maximum ratings at 25°C case temperature (unless otherwise noted)
RATING
SYMBOL
TIP42
Collector-base voltage (IE = 0)
TIP42A
V CBO
TIP42C
TIP42
Collector-emitter voltage (IB = 0)
Emitter-base voltage
Continuous collector current
TIP42A
TIP42B
TIP42C
UNIT
-80
E
T
E
L
O
S
B
O
TIP42B
VALUE
VCEO
VEBO
IC
-100
V
-120
-140
-40
-60
V
-80
-100
-5
V
-6
A
Peak collector current (see Note 1)
ICM
-10
Continuous device dissipation at (or below) 25°C case temperature (see Note 2)
Ptot
65
W
½LIC2
62.5
mJ
Continuous base current
Continuous device dissipation at (or below) 25°C free air temperature (see Note 3)
Unclamped inductive load energy (see Note 4)
Operating junction temperature range
Storage temperature range
Lead temperature 3.2 mm from case for 10 seconds
NOTES: 1.
2.
3.
4.
IB
Ptot
-3
2
Tj
-65 to +150
TL
250
Tstg
-65 to +150
A
A
W
°C
°C
°C
This value applies for tp ≤ 0.3 ms, duty cycle ≤ 10%.
Derate linearly to 150°C case temperature at the rate of 0.52 W/°C.
Derate linearly to 150°C free air temperature at the rate of 16 mW/°C.
This rating is based on the capability of the transistor to operate safely in a circuit of: L = 20 mH, IB(on) = -0.4 A, RBE = 100 Ω,
V BE(off) = 0, RS = 0.1 Ω, VCC = -20 V.
DECEMBER 1970 - REVISED SEPTEMBER 2002
Specifications are subject to change without notice.
1
TIP42, TIP42A, TIP42B, TIP42C
PNP SILICON POWER TRANSISTORS
electrical characteristics at 25°C case temperature
PARAMETER
V(BR)CEO
ICES
ICEO
IEBO
hFE
VCE(sat)
VBE
hfe
|hfe |
Collector-emitter
breakdown voltage
TEST CONDITIONS
IC = -30 mA
MIN
IB = 0
(see Note 5)
TIP42
-40
TIP42A
-60
TIP42B
-80
TIP42C
-100
TYP
MAX
UNIT
V
VCE = -80 V
VBE = 0
TIP42
-0.4
Collector-emitter
VCE = -100 V
VBE = 0
TIP42A
-0.4
cut-off current
VCE = -120 V
VBE = 0
TIP42B
-0.4
VCE = -140 V
VBE = 0
TIP42C
-0.4
Collector cut-off
VCE = -30 V
IB = 0
TIP42/42A
-0.7
current
VCE = -60 V
IB = 0
TIP42B/42C
-0.7
VEB =
-5 V
IC = 0
Forward current
VCE =
-4 V
IC = -0.3 A
transfer ratio
VCE =
-4 V
IC =
- 3A
-0.6 A
IC =
-6 A
(see Notes 5 and 6)
-1.5
V
-4 V
IC =
-6 A
(see Notes 5 and 6)
-2
V
Emitter cut-off
current
Collector-emitter
saturation voltage
Base-emitter
voltage
Small signal forward
current transfer ratio
Small signal forward
current transfer ratio
IB =
VCE =
-1
(see Notes 5 and 6)
mA
mA
mA
30
15
E
T
E
L
O
S
B
O
VCE = -10 V
IC = -0.5 A
f = 1 kHz
20
VCE = -10 V
IC = -0.5 A
f = 1 MHz
3
75
NOTES: 5. These parameters must be measured using pulse techniques, tp = 300 µs, duty cycle ≤ 2%.
6. These parameters must be measured using voltage-sensing contacts, separate from the current carrying contacts.
thermal characteristics
MAX
UNIT
RθJC
Junction to case thermal resistance
PARAMETER
MIN
TYP
1.92
°C/W
RθJA
Junction to free air thermal resistance
62.5
°C/W
MAX
UNIT
resistive-load-switching characteristics at 25°C case temperature
PARAMETER
†
TEST CONDITIONS
†
MIN
ton
Turn-on time
IC = -6 A
IB(on) = -0.6 A
IB(off) = 0.6 A
0.4
µs
toff
Turn-off time
VBE(off) = 4 V
RL = 5 Ω
tp = 20 µs, dc ≤ 2%
0.7
µs
Voltage and current values shown are nominal; exact values vary slightly with transistor parameters.
2
TYP
DECEMBER 1970 - REVISED SEPTEMBER 2002
Specifications are subject to change without notice.
TIP42, TIP42A, TIP42B, TIP42C
PNP SILICON POWER TRANSISTORS
TYPICAL CHARACTERISTICS
TYPICAL DC CURRENT GAIN
vs
COLLECTOR CURRENT
TCS634AD
VCE = -4 V
TC = 25°C
tp = 300 µs, duty cycle < 2%
100
10
1·0
-0·01
-0·1
TCS634AE
-10
VCE(sat) - Collector-Emitter Saturation Voltage - V
hFE - DC Current Gain
1000
COLLECTOR-EMITTER SATURATION VOLTAGE
vs
BASE CURRENT
IC = -300 mA
IC = -1 A
IC = -3 A
IC = -6 A
-1·0
-0·1
E
T
E
L
O
S
B
O
-1·0
-10
-0·01
-0·001
IC - Collector Current - A
-0·01
-0·1
-1·0
-10
IB - Base Current - A
Figure 1.
Figure 2.
BASE-EMITTER VOLTAGE
vs
COLLECTOR CURRENT
-1·2
TCS634AF
VBE - Base-Emitter Voltage - V
VCE = -4 V
TC = 25°C
-1·1
-1·0
-0·9
-0·8
-0·7
-0·6
-0·1
-1·0
-10
IC - Collector Current - A
Figure 3.
DECEMBER 1970 - REVISED SEPTEMBER 2002
Specifications are subject to change without notice.
3
TIP42, TIP42A, TIP42B, TIP42C
PNP SILICON POWER TRANSISTORS
MAXIMUM SAFE OPERATING REGIONS
MAXIMUM FORWARD-BIAS
SAFE OPERATING AREA
IC - Collector Current - A
-100
SAS634AB
tp = 300 µs, d = 0.1 = 10%
tp = 1 ms, d = 0.1 = 10%
tp = 10 ms, d = 0.1 = 10%
DC Operation
-10
-1·0
-0·1
TIP42
TIP42A
TIP42B
TIP42C
E
T
E
L
O
S
B
O
-0·01
-1·0
-10
-100
-1000
VCE - Collector-Emitter Voltage - V
Figure 4.
THERMAL INFORMATION
MAXIMUM POWER DISSIPATION
vs
CASE TEMPERATURE
TIS633AB
Ptot - Maximum Power Dissipation - W
80
70
60
50
40
30
20
10
0
0
25
50
75
100
125
150
TC - Case Temperature - °C
Figure 5.
4
DECEMBER 1970 - REVISED SEPTEMBER 2002
Specifications are subject to change without notice.