Rev. 5/10 5 TO 1000 MHz 10-PIN GULLWING SPDT SWITCH SJ1010 SJ1010 Typical Values Low Insertion Loss . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . High Isolation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . High Output Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . High Third Order I.P. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Low Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TTL Compatible 10-pin Gullwing Package <1.5 dB >30 dB +24.0 dBm +49 dBm +5 Vdc SJ1010 Flatpack Switch Gullwing) Gullwing SPDT Switch Package 10-pin(10-pin SPECIFICATIONS* Parameter Typical Frequency (Min.) 5-1100 MHz Insertion Loss (Max.) 5-100 MHz 100-500 MHz 500-1000 MHz Guaranteed 0 to 50 °C -55 to +85 °C 5-1000 MHz 5-1000 MHz <0.7 dB <1.0 dB <1.5 dB 1.0 dB 1.3 dB 1.8 dB 1.2 dB 1.5 dB 2.0 dB Isolation (Min.) 5-100 MHz 100-500 MHz 500-1000 MHz 47 dB 37 dB 30 dB 45.0 dB 35.0 dB 28.0 dB 43.0 dB 34.0 dB 27.0 dB SWR (Max.) Input/Output 5-100 MHz 100-500 MHz 500-1000 MHz 1.1:1^ 1.1:1^ 1.3:1^ 1.3:1 1.3:1 1.5:1 1.4:1 1.4:1 1.6:1 >+19.0 dBm >+24.0 dBm +18.0 dBm +24.0 dBm +17.0 dBm +23.0 dBm 10† ηsec 20 ηsec 40 ηsec 5 mA 8 mA 10 mA Power Output (Min.) @ 1dB comp. 100-500 MHz 500-1000 MHz Switching Time† 100-1000 MHz DC Current (Max.) * Measured in a 50-ohm system at +5 Vdc unless otherwise specified. ^ Insertion loss state. † 50% TTL control to 10% or 90% RF. Second Order Two Tone Intercept Point . . . . . . . . . . . . . . . Third Order Two Tone Intercept Point . . . . . . . . . . . . . . . . . COM-RF1 COM-RF2 Teledyne Cougar • 408-522-3838 • 408-522-3839 fax www.teledyne-cougar.com • [email protected] INTERMODULATION PERFORMANCE Typical @ 25 °C, +5 Volts, and 400 MHz LOGIC TABLE TTL CONTROL SJ1010 +65 dBm +49 dBm LOW ISOLATION INSERTION LOSS HI INSERTION LOSS ISOLATION LOW is defined as 0 to +0.8V @ 20 μA MAX HI is defined as +2.0 V @ 50 μA typical to +5.5 V @ 300 μA MAX ABSOLUTE MAXIMUM RATINGS Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -62 to +125 °C Maximum Case Temperature . . . . . . . . . . . . . . . . . . . . . . . . +150 °C Maximum DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +5 Volts Maximum Continuous RF Input Power . . . . . . . . . . . . . . . . +35 dBm Maximum Short Term Input Power (1 Minute Max.) . . . . . . +35 dBm Maximum Peak Power (3 µsec Max.) . . . . . . . . . . . . . . . . . . +37 dBm Burn-in Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +125°C DIMENSIONS ARE IN INCHES [MILLIMETERS] 650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected] SJ1010 Typical Performance SJ1010 TYPICAL PERFORMANCE Insertion Loss vs. Frequency KEY: +25 °C +85 °C -55 °C INSERTION LOSS - dB 0 -0.5 -1.0 -1.5 -2.0 -2.5 -3.0 5 10 30 50 100 400 600 FREQUENCY - MHz 800 1000 1200 800 1000 1200 1000 1200 Switching speed @ 0.2 GHz, +6 dBm Isolation vs. Frequency -20.0 ISOLATION - dB -30.0 -40.0 -50.0 -60.0 -70.0 -80.0 OUTPUT POWER - dBm -90.0 Switching speed @ 0.2 GHz, +12 dBm 5 10 30 50 100 400 600 FREQUENCY - MHz Power Output at 1 dB Compression 28.0 26.0 24.0 22.0 20.0 18.0 5 10 30 50 100 400 600 FREQUENCY - MHz 800 Switching speed @ 1 GHz, +6 dBm INTERCEPT POINT - dBm Intercept Point 2nd HAR 70 IP 2 60 50 IP 3 40 30 5 10 30 50 100 400 600 FREQUENCY - MHz 800 1000 1200 Logic Table Switching speed @ 1 GHz, +12 dBm Control Voltage, Vcntl COMM-RF1 COMM-RF2 Low Isolation Insertion Loss High Insertion Loss Isolation Low is defined as 0 to +0.8 @ 20µA MAX High is defined as +2.0 V @ 50 µA typical to +5.5 V @ 300 µA MAX Top Trace: Switch Response Bottom Trace: TTL Contol Time Base: 20 ηs/div 650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected]