FR301 THRU FR307 R FAST RECOVERY RECTIFIER Reverse Voltage: 50 to 1000 Volts Forward Current:3.0Amperes S E M I C O N D U C T O R DO-201AD FEATURES Low leakage Low forward voltage drop 1.0(25.4) MIN JF High current capability High current surge High reliability High temperature soldering guaranteed:260°C/10 seconds at terminals Component in accordance to RoHS 2002/95/EC and WEEE 2002/96/EC 0.210(5.3) 0.190(4.8) DIA 0.375(9.50) 0.285(7.20) MECHANICAL DATA Case: JEDEC DO-201AD molded plastic body Terminals: Plated axial leads, solderable per MIL-STD-750,Method 2026 1.0(25.4) MIN Polarity: Color band denotes cathode end 0.052(1.32) 0.048(1.22) DIA Mounting Position: Any Weight: 0.041 OUNCE,1.18 grams Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (Rating at 25 C ambient temperature unless otherwise specified.Single phase ,half wave ,60HZ,resistive or inductive load. For capacitive load,derate current by 20%.) Symbols FR 301 FR 302 FR 303 FR 304 FR 305 FR 306 FR 307 50 100 200 400 600 800 1000 35 70 140 280 420 560 700 50 100 200 400 600 800 1000 Units Volts Volts Volts Maximum DC Blocking Voltage VRRM VRMS VDC Maximum Average Forward Rectified Current 0.375"(9.5mm)lead length at TA=55 C I(AV) 3.0 Amps Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC method) IFSM 150 Amps VF 1.2 Volts Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum Instantaneous Forward Voltage at 3.0A Maximum DC Reverse Current at rated DC blocking voltage TA=25°C 10 IR Maximum reverse recovery time(Note1) Typical junction capacitance(Note2) Operating junction and storage temperature range A 150 TA=100°C trr CJ 150 TJ TSTG 250 500 ns 60 pF -65 to+150 C Note: 1.Test conditions: IF=0.5A,IR=1.0A,IRR=0.25A. 2.Measured at 1MHZ and applied reverse voltage of 4.0 Volts D.C. JINAN JINGHENG ELECTRONICS CO., LTD. 7-18 HTTP://WWW.JINGHENGGROUP.COM RATINGS AND CHARACTERISTIC CURVES FR301 THRU FR307 FIG.2-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT 5 PEAK FORWARD SURGE CURRENT(AMPERES) AVERAGE FORWARD CURRENT (A) FIG.1-TYPICAL FORWARD CURRENT DERATING CURVE SINGLE PHASE HALF WAVE 60HZ 4 RESISTIVE OR INDUCTIVE LOAD 3 2 1 0 0 25 50 75 100 125 150 175 AMBIENT TEMPERATURE (°C) FIG.3-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 8.3ms SINGLE HALF SINE-WAVE (JEDEC Method) 100 50 30 20 10 1 5 10 50 100 NUMBER OF CYCLES AT 60Hz FIG.4-TYPICAL JUNCTION CAPACITANCE 20 10 80 JUNCTION CAPACITANCE(pF) INSTANTANEOUS FORWARD CURRENT( AMPERES) 150 3 1 0.3 0.1 TJ=25°C Pulse Width=300 µs 0.03 60 40 TJ=25 C 20 10 6 4 2 1% Duty Cycle 1 0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 0.1 0.2 1.8 0.4 1 2 4 10 20 REVERSE VOLTAGE. (V) INSTANTANEOUS FORWARD VOLTAGE (VOLTS) FIG.5-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC NONINDUCTIVE NONINDUCTIVE trr +0.5A (＋) D.U.T. 0 PULSE GENERATOR (NOTE2) 50Vdc -0.25A (ADJUSTABLE) (－) 1 NONINDUCTIVE OSCILLOSCOPE (NOTE1) -1.0A 1cm SET TIME BASE FOR 50/100 ns/cm NOTES:1.Rise Time=7ns max. input lmpedance=1 megohm 22pF 2.Rise Time=10ns max. source lmpedance= 50 ohms JINAN JINGHENG ELECTRONICS CO., LTD. 7-19 HTTP://WWW.JINGHENGGROUP.COM 40 100