NET-ACCESS S-Type and N-Type Cabinets (S7VPPB, SN8VPPB Vertical Patch Panel Brackets) INSTRUCTIONS CM657A © Panduit Corp. 2013 Install Vertical Patch Panel Bracket - S-Type Cabinets • Secure Vertical Patch Panel Bracket to Net-Access S-Type cabinet rear equipment rail with [4] M5 Torx screws (use T25 Torx bit) as shown below. Vertical Patch Panel Bracket • S7VPPB - 700mm Wide Server Cabinets • SN8VPPB - 800mm Wide Server Cabinets -or- alternate mounting location for N-Type switch cabinets [4] M5 Torx Screws (use T25 Torx bit) Vertical Patch Panel (sold separately) Vertical Patch Panel Bracket (installed) Front of Cabinet FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp Page 1 of 2 INSTRUCTIONS CM657A Install Vertical Patch Panel Bracket - N-Type Cabinets • Secure Vertical Patch Panel Bracket to Net-Access N-Type cabinet front vertical post with [4] M5 Torx screws (use T25 Torx bit) as shown below. Vertical Patch Panel Bracket • SN8VPPB [4] M5 Torx Screws (use T25 Torx bit) Vertical Patch Panel Bracket (Alternate mounting location - see page 1) Vertical Patch Panel Bracket (installed) Front of Cabinet For Instructions in Local Languages and Technical Support: www.panduit.com/resources/install_maintain.asp www.panduit.com Page 2 of 2 E-mail: [email protected] Phone: 866-405-6654