Test Probes 4 mm Safety System Type Tip diameter PRUEF 2600 C2 SS 260 PRUEF 2610 FT Test probe shatter - proof insulating sleeve and slender stainless steel tip. Tip for penetration of insulation and oxide layers. 4mm diameter brass socket connection. Connection with safety measuring leads. Accessory (optional): protector and IC - tap SS 260 Tip protection and IC tap. Clipping onto the PRUEF 2, PRUEF 2 S and PRUEF 2600 C2 test probe covers the needle tip and provides protection against injury. Contact is made with ICs without short circuiting or slipping off. Test probe with insulated sleeve and slender, sprung stainless steel tip. This allows a constant pressure to be applied without the tip slipping off the component, even in the smallest measuring points. 4 mm diameter brass socket connection. 2 mm (0.079 in.) – 0.75 mm (0.029 in.) 973865001 972318100 972318101 972327100 972327101 PART NO. / Housing color Technical Data Connection Type stationary tip fixed socket Ø 4 mm Measurement Category (IEC61010) AC/DC 1000V CAT II Current Rating* 1A Contact Resistance 50 mOhm Material Specifications – – – – – – spring-loaded tip fixed socket Ø 4 mm AC/DC 1000 V CAT II 1A 50 mOhm Tip Connection pin/ socket Contact Spring Housing stainless steel nickel plated brass – – – – stainless steel nickel plated brass – PP – PP -20°C to +60°C (-4°F to 140°F) – -25 °C to +80 °C (13°F to 176°F) UL 94 HB – UL 94 HB Voltage Rating Environmental Conditions Temperature range Flamability Rating Housing 21 21 Drawing Measurements are shown in millimeters. Multiply by 0.03937 to convert to inches. 19 ø6 3 ø 4,3 ø4 ø 13 ø2 4,3 34,5 98 20 ø 0,75 1.8 1 8 Handle 10 100 * Please consider derating graph on page 80. 16 For the latest on Altech Test & Measurement specifications please visit www.altechcorp.com/test-equipment ø4 ø 13 Handle 19