Toggles Series GB Rockers General Specifications Electrical Capacity (Resistive Load) Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Logic Level: 0.4VA maximum @ 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. Other Ratings D Contact Resistance: 80 milliohms maximum Insulation Resistance: 500 megohms minimum @ 500V DC Dielectric Strength: 500V AC minimum for 1 minute minimum Mechanical Life: 50,000 operations minimum Electrical Life: 50,000 operations minimum Nominal Operating Force: 1.70N Travel: Pretravel .035” (0.9mm); Overtravel .008” (0.2mm); Total Travel .043” (1.1mm) Materials & Finishes Plunger: Case: Sealing Rings: Movable Contact: Stationary Contacts: Base: Switch Terminals: Lamp Terminals: Environmental Data Operating Temperature Range: Humidity: Vibration: Shock: Polyamide Glass fiber reinforced polyamide Nitrile butadiene rubber Phosphor bronze with gold plating Phosphor bronze with gold plating Glass fiber reinforced polyamide Phosphor bronze with gold plating Phosphor bronze with gold plating –25°C through +55°C (–13°F through +131°F) 90 ~ 95% humidity for 240 hours @ 40°C (104°F) 10 ~ 500Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 15 minutes; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Tilt Tactiles Ultra-Miniature Fully Illuminated Plungers Soldering: Cleaning: Wave Soldering recommended. See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. Automated alcohol based cleaning recommended, 5 minutes maximum. Do not use high-purity alcohol (50% alcohol or more) or organic solvent. High alcohol solution can damage clear plastic. See Cleaning specifications in Supplement section. Standards & Certifications The GB Series illuminated pushbuttons have not been tested for UL recognition or CSA certification. These switches are designed for use in a low-voltage, low-current, logic-level circuit. When used as intended in a logic-level circuit, the results do not produce hazardous energy. Supplement Accessories Indicators Touch PCB Processing D8 www.nkk.com Toggles Series GB Rockers Distinctive Characteristics Pushbuttons Fully illuminated plunger for highly visible status indication with single color LED in red, green, or amber. Ultra-miniature size allows high density mounting, and extremely light weight makes these switches ideal for handheld equipment. D Keylocks Totally sealed body construction prevents contact contamination and allows time- and money-saving automated soldering and cleaning. Insert-molded terminals lock out flux, solvents, and other contaminants. Programmable Illuminated PB Ultra-Miniature Fully Illuminated Plungers Slides Rotaries Award-winning STC contact mechanism with benefits unavailable in conventional mechanisms: smooth, positive detent actuation, increased contact stability, and unparalleled logic-level reliability. (Additional STC details in Terms & Acronyms; see Supplement section.) Tilt Tactiles .100” x .100” (2.54mm x 2.54mm) terminal spacing conforms to standard PC board grid spacing. Round terminals facilitate easier through-hole mounting on PC boards. Touch Nonilluminated pushbuttons available and shown in the Pushbutton section. Supplement Accessories Indicators Actual Size www.nkk.com D9 Series GB Toggles Ultra-Miniature Fully Illuminated Plungers TYPICAL SWITCH ORDERING EXAMPLE Programmable Illuminated PB Pushbuttons Rockers GB 1 Pole 1 5 J Circuit SPDT 5 ON H PC Terminals Actuator J (ON) Clear ( ) = Momentary D F LEDs P Straight C Red H Right Angle D Amber V Vertical F Green DESCRIPTION FOR TYPICAL ORDERING EXAMPLE GB15JHF SPDT ON-(ON) Circuit Right Angle PC Terminals Keylocks Clear Plunger, Green LED POLE & CIRCUIT Rotaries Plunger Position ( ) = Momentary Model SP GB15 Normal Down Normal Down ON (ON) 5-6 5-4 Slides Pole Connected Terminals Throw & Switch/Lamp Schematics Note: Terminal numbers are not actually on the switch. LED circuit is isolated and requires an external power source. Tactiles 5 (COM) SPDT (1) 4 (3) 6 ACTUATOR Tilt J Clear Plunger (4.0) Dia .157 (2.0) Dia .079 (3.3) .130 Supplement Accessories Indicators Touch (1.6) .063 LED COLORS & SPECIFICATIONS LEDs are an integral part of the switch and not available separately. Colors C D F Red Amber Green The electrical specifications shown are determined at a basic temperature of 25°C. Maximum Forward Current I FM 30mA 30mA 30mA If the source voltage exceeds the rated voltage, a ballast resistor is required. Typical Forward Current IF 20mA 20mA 20mA Forward Voltage VF 1.95V 2.0V 2.1V Maximum Reverse Voltage VRM 5V 5V 5V Current Reduction Rate Above 25°C ∆I F 0.40mA/°C 0.40mA/°C 0.40mA/°C The resistor value can be calculated by using the formula in the Supplement section. D10 Ambient Temperature Range www.nkk.com –25° ~ +55°C Series GB Toggles Ultra-Miniature Fully Illuminated Plungers PC TERMINALS (4.5) .177 Rockers (2.54) Typ .100 (0.5) Typ .020 (4.5) .177 (7.0) .276 Pushbuttons (2.54) Typ .100 (0.4) Dia Typ .016 (2.54) Typ .100 (7.0) .276 (2.54) Typ .100 (4.5) .177 D TYPICAL SWITCH DIMENSIONS Straight PC 1 4 (4.0) Dia .157 (3.3) .130 (7.0) .276 6 6 3 (0.6) Dia Typ .024 (2.54) Typ .100 (2.6) .102 (2.54) .100 Terminals 1 & 3 are lamp terminals. GB15JPD 1 3 (0.4) .016 (0.4) Dia Typ .016 (2.6) .102 (2.0) Dia .079 (5.08) .200 (7.8) .307 (3.3) .130 (5.08) .200 (1.6) .063 (10.22) .402 6 5 3 5 6 (0.6) Dia Typ .024 4 (0.5) .020 (2.54) .100 4 (2.54) .100 (5.08) .200 (0.4) Dia Typ .016 (2.54) Typ .100 (7.0) .276 Tilt Slot Right Angle PC (2.54) Typ .100 1 (4.9) .193 (4.0) Dia .157 Terminals 1 & 3 are lamp terminals.GB15JHF 1 4 (4.0) Dia .157 5 3 (0.4) Dia Typ .016 (2.54) .100 (5.3) .209 (7.4) .292 (3.3) .130 (5.08) .200 (1.6) .063 (12.76) .502 6 (0.6) Dia Typ .024 (0.5) Typ .020 (2.54) Typ .100 4 1 (2.54) Typ .100 5 6 (2.6) .102 (2.0) Dia .079 Slot (2.54) .100 3 (5.08) .200 Accessories (0.4) .016 Vertical PC Indicators (0.4) Dia Typ .016 (2.54) .100 (4.5) .177 Terminals 1 & 3 are lamp terminals. www.nkk.com Supplement Rotaries (4.5) .177 (1.6) .063 (2.54) Typ .100 Tactiles (2.0) Dia .079 1 5 (7.0) .276 5 3 Slot (2.54) .100 4 Keylocks P/N This Side (0.4) Dia Typ .016 Programmable Illuminated PB (2.6) .102 (7.0) .276 Vertical (0.5) Typ .020 (0.4) Dia Typ .016 (2.54) Typ .100 (2.54) Typ .100 (0.4) Dia Typ .016 V Right Angle Slides H Straight Touch P GB15JVC D11