API RF Signal Extender for SecNet 11® TM Extend outdoor range of SecNet 11 modem up to 5 miles. • • • • • • Extends range of SecNet 11® for up to 5 miles Ideal for use in a variety of ground mobile applications Supports both SecNet 11 low and high power modes Lightweight, highly portable and ruggedized Easily attaches to MRAP antenna MIL-STD-1275 compliant Designed to improve warfigher communications, the API™ RF Signal Extender is a highly portable, plug-in amplifier/power supply solution that vastly extends the outdoor range of SecNet 11®. The power amplifier can then be attached to the antenna mount plate on the Mine Resistant Ambush Protected (MRAP) vehicle. Overall, the solution is easy to deploy and can significantly improve the availability of secure wireless communications. SecNet 11® is a registered trademark of Harris Corporation. Technical Specifications: API TM RF Signal Extender for SecNet 11® Complete set includes: 1. Amplifier 2. Power supply with integrated bias-T RF Power Amplifier Electrical Specifications Operating Frequency Range: Receiver includes a hard limiter and band pass filter Linear Transmit Power (@SecNet11 output of 17dBm@EVM<3%) Max Saturated Output Power Transmit Gain Transmit Switchover Threshold Transmit Switchover Time Transmitter Protections Receive Gain Max Receiver Linear RF Output Noise Figure Receiver Overload Protection Insertion Loss in Bypass Mode Power Consumption (50% duty cycle, 18Vdc supply, 1W out) (100% duty cycle, 18Vdc supply, 1W out) Operating Temp. Bias-T Electrical Specifications: Insertion Loss Power Input via BNC (center pin is positive) Power Input Protections Max Reverse Voltage Max Over Voltage Max Over Current Power Output Protections Output Short Circuit (LEDs blinking) Output Open Circuit Operating Modes Status LEDs Normal Bypass Output Short Circuit 2400 - 2500MHz 30dBm +1/-0dBm 37dBm +/- 0.5dBm 17dB <=0dBm <500nSec Antenna mismatch, open or short RF in without power 17.5dBm -25dBm <3.2dB <20dBm for indefinite time <3.4dB 0.5A nominal 0.65A nominal -40°C to + 70°C 0.5dB 9V to 36V -40V 80V 1A Current limit of 20mA Bypass (output of 8V) Normal (output of 25V) Green LED on Green and Red LED on LEDs blinking Mechanical: Amplifier Dimension: 1.65” (42 mm) diameter / 5.25” (133 mm) long (includes RF connectors) Enclosure: Weatherproof, machined aluminum Weight: 8.8 oz. (249 g) Product Information Connectors: Type N male to antenna port and N female to radio port www.apitech.com Power Supply/ Bias-T Dimension: 4.10” x 3.40” x 1.16” (includes RF connectors) Enclosure: Machined aluminum housing with clear iridite finish Weight: 6.0 oz. (226 g) Manual Override Switch: Bypass and normal mode Connectors: Type N female both ends +1 814.467.9060 [email protected]