M ICROWAVE A Division of Crystek Corporation PERFORMANCE SPECIFICATION MIN TYP Output Frequency: MAX UNITS 2000 Frequency Accuracy: MHz ±150 Operating Temperature Range: -40 Output Power: +5.0 Input Power: 4.75 ppm +85 °C dBm 5.0 5.25 VDC 30 50 mA 2 Harmonic: -20 -15 dBc Sub-Harmonic: -50 dBc Phase Noise @ 1kHz offset: -105 dBc/Hz Phase Noise @ 10kHz offset: -133 dBc/Hz Phase Noise @ 100kHz offset: -142 dBc/Hz Phase Noise @ 1MHz offset: -158 dBc/Hz Phase Noise @ 10MHz offset: -165 dBc/Hz Input Current: nd SIDE VIEW BOTTOM VIEW Gold Finish 0.700 SQ (17.78 SQ) Solder Mask [Vcc] 0.250 (6.35) 0.030 (0.76) [RF] 7 5 0.375 12 (Top View) 4 0.275 0.375 0.275 0.000 1 2 3 Pad Connection 5 11 Others RF-OUTPUT Vcc GROUND Unless otherwise specified, Dimensions are in: IN (mm) Pad Location Dimensions are in: Inches 0.750 0.475 10 0.475 6 11 PAD LOCATION 0.475 0.000 TOP ORIENTATION MARK 8 0.375 [RF] 9 0.275 [Vcc] CRYSTEK CRFS75 2000M Date Code 0.750 (19.05) 0.750 0.475 0.750 (19.05) 0.375 0.040 (1.02) TOP VIEW 0.275 0.052 (1.32) Product Control: Crystek Part Number: CRFS75-2000 Release Date: 25-Feb-2015 Revision Level: E Responsible: C. Vales CRYSTEK CORPORATION Page 1 of 3 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation Suggested PCB Layout 0.790 (20.07) 0.060 (1.52) 0.048 (1.22) 0.790 (20.07) 0.052 [RF] (1.32) [Vcc] Unless otherwise specified, Dimensions are in: IN (mm) 0.040 (1.02) Pin 1 Notes: 1. Taper RF Line to match board geometry for a 50 ohm line 2. Denotes Copper on Mother Board (SMOBC) 3. Denotes No Mask RECOMMENDED REFLOW SOLDERING PROFILE TEMPERATURE Ramp-Up 3°C/Sec Max. Critical Temperature Zone Ramp-Down 6°C/Sec. 260°C 217°C 200°C 150°C Preheat 180 Secs. Max. 8 Minutes Max. 90 Secs. Max. 260°C for 10 Secs. Max. NOTE: Reflow Profile with 240°C peak also acceptable. Product Control: Crystek Part Number: CRFS75-2000 Release Date: 25-Feb-2015 Revision Level: E Responsible: C. Vales CRYSTEK CORPORATION Page 2 of 3 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation Frequency vs Temperature Parameter Conditions Mechanical Shock MIL-STD-883, Method 2002, Condition B Mechanical Vibration MIL-STD-883, Method 2007, Condition A Solderability MIL-STD-883, Method 2003 Solvent Resistance MIL-STD-202, Method 215 Resistance to Soldering Heat MIL-STD-202, Method 210, Condition I or J Thermal Shock MIL-STD-883, Method 1011, Condition A Moisture Resistance MIL-STD-883, Method 1004 Product Control: Crystek Part Number: CRFS75-2000 Release Date: 25-Feb-2015 Revision Level: E Responsible: C. Vales CRYSTEK CORPORATION Page 3 of 3 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com