M ICROWAVE A Division of Crystek Corporation PERFORMANCE SPECIFICATION MIN TYP MAX UNITS 169 MHz 2.9 VDC Lower Frequency: Upper Frequency: 218 Tuning Voltage: 0.1 MHz Supply Voltage: 2.85 3.0 3.15 VDC Output Power: -2.0 0 +2.0 dBm 5 mA Supply Current: nd Harmonic Suppression (2 Harmonic): -20 Pushing: 0.5 1.0 MHz/V Pulling, all Phases: 1.0 1.5 MHz pk-pk Tuning Sensitivity: Phase Noise @ 10kHz offset: TX Modulation Sensitivity: -15 TX Modulation Port Input Capacitance: dBc 35 MHz/V -110 dBc/Hz -20 -25 100 Residual FM (100Hz - 10kHz) Load Impedance: kHz/V pF 5 Hz RMS 470 pF 50 Input Capacitance: Operating Temperature Range: -30 +70 °C Storage Temperature Range: -45 +90 °C Phase Noise (1 Hz BW, Typical) Tuning Curve (Typical) Page 1 of 2 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation BOTTOM VIEW SIDE VIEW Gold Finish [RF] 0.465 SQ (11.81) SQ 0.030 (0.76) 0.220 (5.59) [Vcc] 0.052 (1.32) 0.025 (0.64) 0.100 (2.54) 0.280 0.380 TOP VIEW 0.180 [Vt] [Vm] 0.080 0.040 (1.02) 12 11 10 9 0.500 (12.70) 0.215 15 0.115 16 0.405 7 0.305 6 0.205 5 0.105 Pad Connection 1 2 10 14 Others Vm Vt RF-OUTPUT Vcc GROUND PAD LOCATION 0.000 1 0.000 TOP ORIENTATION MARK 8 2 3 4 0.500 14 0.415 0.315 0.315 13 0.215 0.415 0.115 CRYSTEK CVCO55FLM 0169-0218 YYWW 0.500 (12.70) 0.500 Unless otherwise specified, Dimensions are in: IN (mm) Pad Location Dimensions are in: Inches TAPE AND REEL 0.059 Ø TYP (1.50 Ø) TYP 0.157±0.004 (4.00±0.10) DIRECTION OF FEED 0.945±0.012 (24.00±0.30) 0.630±0.004 (16.00±0.10) Drawing not to scale Product Control: Crystek Part Number: CVCO55FLM-0169-0218 Release Date: 16-Dec-2013 Revision Level: E Responsible: C. Vales CRYSTEK CORPORATION Specification is subject to change without notice Page 2 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com