M ICROWAVE A Division of Crystek Corporation PERFORMANCE SPECIFICATION MIN TYP Lower Frequency: Upper Frequency: MAX UNITS 1032 MHz 5.0 VDC 1032 MHz Tuning Voltage: 0 Supply Voltage: 4.75 5.0 5.25 VDC Output Power: +10.0 +12.5 +15.0 dBm Supply Current: 35 nd mA Harmonic Suppression (2 Harmonic): -10 -5 dBc Pushing: 5.0 10.0 kHz/V Pulling, all Phases: 7.0 10.0 kHz pk-pk Tuning Sensitivity: 120 Phase Noise @ 10kHz offset: -135 -131 dBc/Hz Phase Noise @ 100kHz offset: -149 -146 dBc/Hz Phase Noise @ 1MHz offset: -163 -160 dBc/Hz Phase Noise @ 10MHz offset: -170 -167 dBc/Hz 22 pF Load Impedance: kHz/V 50 Input Capacitance: Operating Temperature Range: -20 +70 °C Storage Temperature Range: -45 +90 °C G-sensitivity: -9 0.9×10 per g Phase Noise (1 Hz BW, Typical) Page 1 of 2 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation BOTTOM VIEW SIDE VIEW Gold Finish [RF] Solder Mask 0.465 SQ (11.81 SQ) 0.030 (0.76) 0.100 (2.54) 0.052 (1.32) 0.025 (0.64) 0.315 14 0.215 15 0.115 16 0.280 0.380 10 9 0.405 7 0.305 6 0.205 5 0.105 Pad Connection 2 10 14 Others Vt RF-OUTPUT Vcc GROUND PAD LOCATION 0.000 1 0.000 TOP ORIENTATION MARK 8 2 3 4 0.500 13 11 0.415 0.415 12 0.315 0.500 (12.70) CRYSTEK CVCO55CX 1032-1032 YYWW 0.500 0.180 0.500 (12.70) 0.215 BOTTOM ORIENTATION MARK 0.080 TOP VIEW 0.040 (1.02) 0.115 [Vt] 0.150 (3.81) [Vcc] Unless otherwise specified, Dimensions are in: IN (mm) Pad Location Dimensions are in: Inches TAPE AND REEL 0.059 Ø TYP (1.50 Ø) TYP 0.157±0.004 (4.00±0.10) DIRECTION OF FEED 0.945±0.012 (24.00±0.30) 0.630±0.004 (16.00±0.10) Drawing not to scale Product Control: Crystek Part Number: CVCO55CX-1032-1032 Release Date: 05-Feb-2013 Revision Level: A Responsible: C. Vales CRYSTEK CORPORATION Specification is subject to change without notice Page 2 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com