Operation Manual

AS1329 - Evaluation Board
Application Note
AS1329
Evaluation Board Application Note
www.austriamicrosystems.com
Revision 1.00
1-4
AS1329 - Evaluation Board
Application Note
General Description
Board Description
Figure 1: Board Description - Connector
Figure 2: Board Description - Measurements Points
Connector Description
Label
Jumper
Description
Info
A
B
C
Vin
GND
SHDNN
Power Supply Connectors for Vin and
Ground.
Active-Low Logic Shutdown Input
+0.85V to Vout
D
On / Off
SHDNN Shutdown Jumper
0/OFF = The AS1329 is off and the current into
Vin is ≤1µA (typ).
E
Vout
Power Output Connector
3.3V = Fixed Output Voltage 3.3V
F
3.3V / 5V
Output Voltage Jumper
5V = Fixed Output Voltage 5.0V
1/ON = The AS1329 is on.
Measurement Points Description
Label
Jumper
Description
Info
G
H
I
J
K
L
SW
Vin
GND
FB
SHDNN
Vout
External Inductor
Power Supply Connectors for Vin and
Ground.
Feedback Voltage Connector
Active-Low Logic Shutdown Input
Power Output Connector
Measurement Points
Operational sequence
1.
If not present get the datasheet for the AS1329 from www.austriamicrosystems.com. Drive the IC on the evaluation board only
with the recommended settings and values as described in the datasheet.
2.
Connect a +0.85V to Vout power supply (Vin “A” and GND “B”).
3.
Perform measurements at the measurement points.
Have fun using the Demoboard. If there are questions do not hesitate to contact us. See contact information at the end of the application
note.
www.austriamicrosystems.com
Revision 1.00
2-4
AS1329 - Evaluation Board
Application Note
Layout of demoboard
Board schematics and layout
Figure 3: Schematics
Figure 4: Top view
Figure 5: Bottom view
Assembly List
Label
Cin
Cout
L1
Info
Type
Manufacturer
22µF, 6.3V, 0805, X5R
GRM21BR60J226ME39L
Murata
3.3µH, 1.4A, 0.1Ω
LPS4012-332MLB
Coilcraft
www.austriamicrosystems.com
Revision 1.00
3-4
AS1329 - Evaluation Board
Application Note
Copyright
Copyright © 1997-2008, austriamicrosystems AG, Schloss Premstaetten, 8141 Unterpremstaetten, AustriaEurope. Trademarks Registered ®. All rights reserved. The material herein may not be reproduced, adapted,
merged, translated, stored, or used without the prior written consent of the copyright owner.
All products and companies mentioned are trademarks or registered trademarks of their respective companies.
Disclaimer
Devices sold by austriamicrosystems AG are covered by the warranty and patent indemnification provisions
appearing in its Term of Sale. austriamicrosystems AG makes no warranty, express, statutory, implied, or by
description regarding the information set forth herein or regarding the freedom of the described devices from
patent infringement. Austriamicrosystems AG reserves the right to change specifications and prices at any time
and without notice. Therefore, prior to designing this product into a system, it is necessary to check with
austriamicrosystems AG for current information.
This product is intended for use in normal commercial applications. Applications requiring extended temperature
range, unusual environmental requirements, or high reliability applications, such as military, medical life-support
or life sustaining equipment are specifically not recommended without additional processing by
austriamicrosystems AG for each application. For shipments of less than 100 parts the manufacturing flow might
show deviations from the standard production flow, such as test flow or test location.
The information furnished here by austriamicrosystems AG is believed to be correct and accurate. However,
austriamicrosystems AG shall not be liable to recipient or any third party for any damages, including but not
limited to personal injury, property damage, loss of profits, loss of use, interruption of business or indirect,
special, incidental or consequential damages, of any kind, in connection with or arising out of the furnishing,
performance or use of the technical data herein. No obligation or liability to recipient or any third party shall arise
or flow out of austriamicrosystems AG rendering of technical or other services.
Contact Information
Headquarters
austriamicrosystems AG
A-8141 Schloss Premstätten, Austria
T. +43 (0) 3136 500 0
F. +43 (0) 3136 5692
For Sales Offices, Distributors and Representatives, please visit:
http://www.austriamicrosystems.com/contact-us
www.austriamicrosystems.com
Revision 1.00
4-4