CY8CKIT-059 PSoC 5LP Prototyping Kit Quick Start Guide

CY8CKIT-059 PSOC® 5LP PROTOTYPING KIT QUICK START GUIDE
KitProg
P0_1
P0_0
P3_6
P3_5
P3_4
P3_0
GND
GND
P3_0
P3_1
EXT REF1*/P3_2
P3_3
P3_4
P3_5
P3_6
P3_7
P15_0
P15_1
XTAL_OUT */P15_2
XTAL_IN */P15_3
CMOD*/P15_4
P15_5
P0_0
P0_1
SAR1*/P0_2
EXT REF0*/P0_3
SAR0*/P0_4
P0_5
P0_6
P0_7
RESET
GND
VDD
PSOC® 5LP
(Target)
Note: * An external capacitor is connected to this pin.
P12_7/UART TX
P12_6/UART RX
P12_1/I2C SDA
P12_0/I2C SCL
P12_5
GND
VBUS
VDDIO
GND
P1_7
P1_6
P1_5
P1_4
P1_3
P1_2
P1_1/SWDCLK
P1_0/SWDIO
P12_0/I2C SCL
P12_1/I2C SDA
P12_2
P12_3
P12_4
P12_5
P12_6/UART RX
P12_7/UART TX
P2_7
P2_6
P2_5
P2_4
P2_3
P2_2/SW1
P2_1/LED1
P2_0
1
• Connect the board to your computer
using the USB connector
2
• Amber LED indicates power on
• Green LED indicates status
• Blue LED on the board blinks
3
For more information on the kit, please go to the following web page:
www.cypress.com/CY8CKIT-059
Thank you for supporting PSOC® !
© 2015 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the
properties of their respective owners. 001-96294 Rev.*A
Design the way you think!