C8051F300 Pinout

C8051F30x Prototyping
Package
C8051F300P
Mixed-Signal 8k ISP FLASH MCU Family
C8051F30X FAMILY PROTOTYPE
PACKAGE
C8051F300P
•
•
The C8051F30x family of devices provides a
quality mixed-signal, in-system programmable, system-on-chip microcontroller solution in
an 11-pin micro lead package (MLP-11). The
small package size (3x3 mm) reduces board
space requirements, but can be difficult to use
for prototyping. For this reason, the
C8051F300P is offered in a standard 300 mil
PDIP-14 package.
•
•
Available in prototype quantities
Standard 14-pin PDIP (300 mil) package for use in through-hole PCBs and
“breadboards”
Functionally equivalent to C8051F300
See the C8051F30x Family Datasheet
for full device specifications
C8051F300P Pin Assignments
1
14
NC
P0.0
2
13
GND
P0.1
3
12
C2D / P0.7
VDD
4
11
P0.6
P0.2
5
10
C2CK / /RST
P0.3
6
NC
7
C8051F300P
Rev 1.1 12/03
NC
9
P0.5
8
P0.4
Copyright © 2003 by Silicon Laboratories
C8051F300P
Contact Information
Silicon Laboratories Inc.
4635 Boston Lane
Austin, TX 78735
Tel: 1+(512) 416-8500
Fax: 1+(512) 416-9669
Toll Free: 1+(877) 444-3032
Email: [email protected]
Internet: www.silabs.com
The information in this document is believed to be accurate in all respects at the time of publication but is subject to change
without notice. Silicon Laboratories assumes no responsibility for errors and omissions, and disclaims responsibility for any consequences resulting from the use of information included herein. Additionally, Silicon Laboratories assumes no responsibility
for the functioning of undescribed features or parameters. Silicon Laboratories reserves the right to make changes without further notice. Silicon Laboratories makes no warranty, representation or guarantee regarding the suitability of its products for any
particular purpose, nor does Silicon Laboratories assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. Silicon Laboratories products are not designed, intended, or authorized for use in applications intended to support or sustain life, or for any
other application in which the failure of the Silicon Laboratories product could create a situation where personal injury or death
may occur. Should Buyer purchase or use Silicon Laboratories products for any such unintended or unauthorized application,
Buyer shall indemnify and hold Silicon Laboratories harmless against all claims and damages.
Silicon Laboratories and Silicon Labs are trademarks of Silicon Laboratories Inc.
Other products or brandnames mentioned herein are trademarks or registered trademarks of their respective holders.
2
Rev. 1.1