CONTROL PANELS | ECP BUS 4219 Description: Addressable eight-zone expander for Honeywell ECP bus addressable systems Compatibility: ■ All VISTA control panels that are compatible with ECP bus zone expandability such as VISTA-20P and VISTA-21iP ■ Not compatible with V-Plex control panels Product advantages: ■ Can be located anywhere along the four-wire addressable ECP bus ■ Simple DIP switch addressing to select range of zone numbers ■ Adds up to eight class B zone inputs to an ECP bus addressable system, each with 1K end-of-line resistors ■ Class B loops provide a broad, 300 ohm tolerance ■ Supervised for open, shorted and normal circuit conditions ■ UL Listed for commercial burglary applications Product dimensions: 6.438" W x 4.25" H x 1.25" D Power: Supplied by the control panel’s four-wire ECP bus: 30mA at 12VDC ■ External power supply option: 30mA at 12VDC (maximum) ■ Temperature: 32º F to 122º F (0º C to 50º C) Recommended use: Use for commercial systems when deploying conventional detectors in an ECP zone expandable system Humidity: 5-95% relative, non-condensing Mounting recommendations: ■ On a flat surface, centrally located to monitor up to eight zones from nearby detectors ■ Locate anywhere on the ECP bus Included items: Eight 1K end-of-line resistors Listings: UL Listed to UL1610, UL1635, UL464, UL609, UL365, UL1641, UL985, UL1023 4219 DIP SWITCH FOR SETTING ADDRESS AND ZONE A RESPONSE REED (TAMPER) SWITCH TAMPER JUMPER POSITION 4219 IN CABINET (NOT TAMPERED) 4219 REMOTE (TAMPER PROTECTED) 4-PIN CONSOLE PLUG CONNECTIONS SAME AS TB2 ▲ ▲ ▲ ▲ TB1 1 2 3 4 5 6 7 9 8 10 11 12 Call 1-800-467-5875 for more information. 4 4 3 2 3 1 1 2 GRN DATA OUT TO CONTROL BLK (–) GROUND RED YEL (+) 12V DATA IN FROM CONTROL TERMINATE EACH PROGRAMMED ZONE WITH 1000 OHM END-OF-LINE RESISTOR (EACH ZONE'S MAX. LOOP RESISTANCE: 300 OHMS + E.O.L.) 1K ZONES: A TB2 B C D E F G H 13