Datasheet

DG81C
sub miniature automotive power relay
• Sub miniature - only 15.7 x 12.3 x 13.8mm
• Up to 2 x 35A SPST-NO-DM
• For indicators, hazard warning & ABS
• Cost effective
• RoHS Compliant
Contacts
Contact number & arrangement
SPST-NO-DM (1 Form U)
Contact material
AgNi0.15; AgSnOInO; AgCdO
Max. switching voltage
Min. switching current / voltage
DC 16VDC (consult factory for 24VDC)
1mA/5VDC (AgNi0.15), 0.5A/12VDC (AgSnOInO)
Rated load
DC1 2 x 30A
Max. continuous current
DC1 2 x 30A (2 mins)
Max. switching current
Make 2 x 35A (Lamp load inrush)
Break 2x 12.5A
Initial resistance
100mΩ, max. at 0.1A/6VDC
Coil
Rated voltage
DC 6...12V
Must release voltage
See coil table 1
Operating range of supply voltage
See coil table 1
Rated power consumption
DC 0.85W
Insulation
Insulation resistance
100MΩ at 500VDC, 50%RH
Dielectric strength
coil to contact 500Vrms, 1min
contact to contact 500Vrms, 1min
General Data
Operating time (typical)
mS 10
Release time (typical)
mS 5
Electrical Life
ops 1 x 105
Mechanical life
ops 1 x 107
Dimensions
Weight
L x W x H 15.7 x 12.3 x 13.8mm
6g approx.
Ambient temperature
storage -40 to 100°C
operating -40 to 85°C
Shock resistance
Functional: 10g 11mS; Destructive: 100g
Vibration resistance
DA 1.5mm 10-55Hz
Page 1 of 2 Ref: DG81C 121913JHM
www.aecsensors.com
Sales Department Tel: (888) 847-6552
DG81C
sub miniature automotive power relay
Coil Data
Table 1
Coil Voltage Code
Nominal Voltage (VDC)
Coil Resistance (Ω)
±10%
Must operate voltage
max. (VDC)
Must release voltage
min. (VDC)
1006
6
42
3.5
0.5
1009
9
94
5.2
0.7
1010
10
117
6.3
0.8
1012
12
167
7.3
1.0
Ordering codes
Contact material
Type
D
G
8
1
C
-
Contact
arrangement
8
U
Cover protection
and mounting
-
5
Coil code
-
Contact material
20
-
AgNi (90/10)
70
-
AgSnOInO
80
-
AgNi (0.15)
See coil table 1
Contact arrangement
8U
-
SPST-NO-DM
Cover protection category
2
-
in cover, flux tight - IP40
3
-
in cover, sealed - IP67
Connection mode
5
-
for PCB
Overall Dimensions, PCB Mounting Holes & Wiring Diagram
Dimensions in mm
Notes:
1) All parameters, unless otherwise specified, are measured at an ambient temperature of 23°C.
2) Maximum make current refers to inrush current of lamp load.
3) Electrical life obtained at lamp load, at resistive load 2 x 6A, 14VDC with 1ms ON, 14ms OFF.
4) Electrical life is strongly dependent of switching frequency, ON/Off ratio, environmental conditions and load type.
Specifications are subject to change without notice. E&OE.
Page 2 of 2 Ref: DG81C 092310JHM
www.aecsensors.com
Sales Department Tel: (888) 847-6552